Seaside Casual Sonoma Gathering Table 075 User manual

Page 1
075- rev A
Seaside Casual Furniture | 11 Industrial Drive Coventry, RI 02816 | 800-809-3114 | [e-mail]
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
Carefully remove contents from box. Make sure that all parts and hardware
are included using the Parts List below.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
x 2
End Caps
80mm Hex Lag
Stretchers
Table Top Assembly
x 1
Part Code: 4MMALLEN
Actual Size
4mm Allen Wrench
x 1
x 1
x 2
x 4
80” Sonoma Gathering
Table
(075)
Part Code: 316-1/4-10-80HL
ASSEMBLY INSTRUCTIONS
Leg Assemblies
4mm Allen Wrench (included); #2 Phillips Head Screwdriver;
Tools Required:
Part Code: 316-8X1-3/4PFDS
Actual Size
1-3/4” Phillips Head Screw
x 8
Actual Size
Angle Braces
x 2
Actual Size
3/4” Phillips Pan Head Screw
x 6
Part Code: 316-8X1-1/4PFDS
Actual Size
1-1/4” Phillips Head Screw
x 4 Part Code: 316-8X3/4PPS

Page 2
075- rev A
2ATTACH STRETCHER TO LEG
ASSEMBLIES
Attach stretcher leg assemblies using (4)
80 mm Hex Lags thru counter-bored
holes in Leg Assembly into pilot holes in
both sides of
Stretcher.
Align holes in leg aluminum with large
holes in the long table top aluminum. Se-
cure with (4) 1-
1/4” Phillips
Head Screws.
3ATTACH BASE TO TABLE TOP
Secure center of leg aluminum to table top using
(6) 3/4” Phillips Pan Head Screws. Hold at a
slight angle to access holes in aluminum.
4ATTACH ALUMINUM TO TABLE
TOP
Align angle braces to stretcher assembly and ta-
ble top as shown. Secure using (4) 1-3/4” Phil-
lips Head Screws.
5ATTACH ANGLE BRACES
Insert End Caps into threaded insert in Leg Assem-
bly. Turn clockwise until snug. Continue turning
until in line with the Stretcher as shown. Secure end
caps into legs with (4) 1-3/4” Phillips Head Screws.
7SECURE END CAPS