Harrie Leenders Ysen User manual

1 Harrie Leenders Haardkachels BV
Manual Ysen, due to changes, October 2014.
Ysen
Manual

2 Harrie Leenders Haardkachels BV
Manual Ysen, due to changes, October 2014.
Installation
Dismounting
door
Use magnets to place the
protection cardboard in the
upper left corner of the door.
Lift the door off the hinge
pins and remove it from the
mantle.
Remove
screws
Remove 4 screws from the top and
bottom of the mantle.
Remove
mantle
Pry the mantle loose with a
plastic tire lever.
Carefully lift the mantle and
turn it off the hinge pins in
the left corner.
Transport
Dismantle the Ysen from the
pallet with 4 screws.
Place the hand truck to the
front side of the Ysen.

3 Harrie Leenders Haardkachels BV
Manual Ysen, due to changes, October 2014.
Installation
Adjustments
Level the Mats with the
adjusting screws in the
corners.
Mount the mantle: put it on
the hinge pins in the left
corner.
Placing
door
Install the four screws in the
corners of the mantle.
Put the door back into the
hinge pins of the mantle.

4 Harrie Leenders Haardkachels BV
Manual Ysen, due to changes, October 2014.
Instructions
Installation
All local regulations including those referring to national and European standards must be
observed when using the appliance.
To ensure warranty the appliance has to be installed by a prorerly qualified technician in service of a
Harrie Leenders Haardkachels dealer. See leenders.nl for a current list of addresses of recognised dealers
or contact the manufacturer.
The stove is susceptible to scratching. Handle with care.
The appliance is not suitable for a shared flue system.
The appliance must be installed on a floor having sufficient bearing capacity.
Ensure adequate access for cleaning the appliance, the flue-gas connection and the chimney.
After installation, check the draught by burning some kindling wood.
Use
Ensure that there are no flammable materials in close vicinity to the stove.
The appliance is only suitable to be fired with the door closed.
Parts of the appliance and the surface in particular are hot when touched when the appliance is being
used. Take appropriate measures.
Use firewood abt. 25 cm long and abt. 7 cm thick. Place it flat on the bottom. Place no more than 3 logs in
the stove at a time. Add wood to the stove when the fire is going down, after burning for about 1 hour.
Do not use the appliance as a multi-burner. Do not use unsuitable fuels or any fuels not recommended
and, especially, do not use any liquid fuels.
Ensure there is sufficient ventilation/air supply in the room where the stove is installed. Air extractors such
as a cooker hood may cause problems due to flue gases escaping from the stove into the room.
Maintenance
Ensure maintenance of the appliance at regular intervals to be carried by a competent technician.
Ensure that the flue-gas connection and the chimney are cleaned at regular intervals.
Check to ensure that the chimney is still clear before lighting the stove again, when the appliance has not
been used for a long time.
If in spite of precautions having been taken, nevertheless a chimney fire should occur (a roaring noise in
the chimney), proceed as follows:
-Immediately shut the air supply and the door of the stove.
-Call the fire brigade.
-Ventilate the house.
-Quickly extinguish the fire in the stove with sand or soda to prevent smoke from getting into your house.
-Never use water to extinguish the fire.
-After a fire, ensure that the chimney is first swept and inspected for any damage and leaks.
Care
Order your partner some flowers.

5 Harrie Leenders Haardkachels BV
Manual Ysen, due to changes, October 2014.
Regulations
Safety
Glass is quite susceptible to breaking and broken glass is quite sharp. Take appropriate measures.
For general safety, we refer to the VCA guidelines.
•Note: After installation, ensure there is no inflammable and/or explosion-hazardous material in or on
the stove such as a spray can, packing material and the like.
Safety
distances
Safety distance to flammable materials:
Rear wall; 25cm. Temperature at safety test; 65°C.
Side wall; 40cm. Temperature at safety test; 77°C.
Specification
s
Nominal power = 9,9 kW
Power range = 4-12 kW
Flue gass mass flow = 8,1 g/s
Appliance weight = 300 kg
Minimum chimney draught = 12 Pa
Flue gas temperature directly over the stove = 266 °C
Service
It is not permitted to make any changes or modifications to the appliance without the manufacturer’s
prior authorization.
Only use replacement parts reccomended by the manufacturer.
Instructions, sizes and other service materials are available on service.leenders.nl