Harwin M80-940 Series User manual

IS-26 Issue: 2 Date: 03.10.07 C/Note: 9874 Page 1 of 3
DATAMATE CABLE HOOD ASSEMBLY INSTRUCTIONS
M80-940, M80-941, M80-942, M80-943 Series
ASSEMBLY INSTRUCTIONS
1. Crimp the contacts (see Instruction Sheet IS-01 for instructions on using Hand Crimp Tool
M22520/2-01 and appropriate Positioner). Insert the contacts into the mould (see
Instruction Sheet IS-25 for instructions on using Datamate Assembly Tool Z80-280). The
completed assembly will resemble this:
2. Place the assembled connector into one half of the cable hood (both halves are identical),
and make sure that all the wires lay within the rear channel of the hood:
Harwin North America Harwin Europe Harwin Asia
T: [phone] F: [phone] T: [phone] F: [phone] T: [phone] F: [phone]
E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com.sg

IS-26 Issue: 2 Date: 03.10.07 C/Note: 9874 Page 2 of 3
3. If added strain relief is required, fit a cable tie around the wires and through the cable tie
slots in the rear channel of the hood moulding:
4. Pull the cable tie tight, and then cut off any excess with suitable cutters:

IS-26 Issue: 2 Date: 03.10.07 C/Note: 9874 Page 3 of 3
5. Fit the second Cable Hood moulding. Use a No.1 Pozidriv screwdriver to assemble the two
retaining screws (one in each side of the hood). Tighten the retaining screws to a torque of
18Ncm – DO NOT OVER-TIGHTEN:
6. Finished Datamate Cable Hood assembly: