SKU 66260 For technical questions, please call 1-800-444-3353. Page 3
Secure the vise to the Vise Mount Plate (3).4.
Slide a Flat Washer (7) onto a Mounting Bolta.
(6)
Drop the Bolt/Washer assembly downb.
through the hole in the vise and through the
Vise Mounting Hole (4).
From below the Vice Mount Plate (3), slidec.
on another Flat Washer (7) and screw a
Lock Nut (8) onto the bolt.
Repeat for the three remaining Mountingd.
Bolts.(6)
With 17mm wrenches or other appropriate5.
tools, tighten the Mounting Bolts (6) and Lock
Nuts (8) securely.
Unless the Vise is needed elsewhere for6.
other tasks, it can be left mounted on the
Hitch Mount Vise Plate, but remove the Vise
Plate/Vise from the vehicle before driving.
After use, brush off and wipe down the Vise7.
Plate.
To remove the Hitch Mount Vise Plate from8.
the vehicle’s receiver.
Pull out the Hairpin Clip (2) that locks thea.
Receiver Retaining Pin (5) in position.
Slide the Receiver Retaining Pin back out.b.
Slide the Hitch Mount Vise Plate out of, and9.
away from the vehicle’s receiver.
Reinstall the Receiver Retaining Pin and10.
slide the Hairpin Clip back so they do not
become lost.
Store this Vise in a clean, dry location away11.
from children.
MAINTENANCE/REPAIR
Maintenance
The Hitch Mount Vise Plate needs no main-1.
tenance other than brushing off and wiping
down after use.
Clean off any chips, oil, grease, dirt, or othera.
debris.
Repair
Before use, a quick check is recommended1.
to see if there are cracks or bent parts.
If the Receiver Tube (1) or Vise Mount Plate2.
becomes damaged, it should be repaired by
a qualied technician.
PLEASE READ THE FOLLOWING
CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS
PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS DOCUMENT AS A REFERENCE TOOL ONLY.
NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED
TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT
HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND
LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
PARTS LIST & ASSEMBLY
DIAGRAM
PARTS LIST
Parts Description Qty
1 Receiver Tube 1
2 Hairpin Clip 1
3 Vise Mount Plate 1
4 Vise Mounting Holes 4
5 Receiver Retainting Pin 1
6 Mounting Bolts - M10 x 1.50 x
40mm 4
7 Flat Washer - M10 8
8 Lock Nut - M10 x 1.50 4
