To mount a unit on the RK-UT1:
1. Place the first unit on the rack (for example, the
Kramer PA-120Z).
2. While holding the PA-120Z in place, flip over the
RK-UT1.
3. Attach the appropriate number of M3x5 screws
(supplied) through the holes on the RK-UT1 to the
underside of the PA-120Z.
4. Repeat steps 1 to 3 for all additional devices.
To install the RK-UT1 underneath a table:
1. Place the unit on the underside of a table and mark
the correct location (of the table mounting screw
holes).
2. Insert the six M4.2X18 wood screws (supplied) into
the six rim screw holes (three on each side) and
tighten them to attach the RK-UT1 to the table.
If your Kramer device does not have screw holes on its
underside, mount it via the screw holes on the sides of
the RK-UT1.
To mount a blank panel (optional) to cover any empty
rack spaces:
1. Place the blank panel in place.
2. Insert two M3x5 screws through the holes on the
RK-UT1 that fit the holes on the blank panel
(optional, not supplied).
