hayneedle Coral Coast NINB005-1 User manual

ITEM NAME: Coral Coast Sanders Steel Mesh Outdoor Extension Patio Dining Table
SKU:NINB005-1
For assistance with assembly, please contact customer service
1-888-880-4884
1/7

Qty:1 Qty:2
Leg Qty:4
DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF FINGER ENTRAPMENT
PRE-ASSEMBLY PREPARATION:
PANEL AND FITTINGS IDENTIFICATION:
Table Top (A)
Table Rim (B)
1/7
!
IMPORTANT: PLEASE READ INSTRUCTIONS BEFORE ASSEMBLY
- Identify all parts prior to assembly against the part list.
- Remove all packaging and place parts on a non-abrasive surface to avoid scratching.
- If any parts are missing or damaged DO NOT ATTEMPT TO ASSEMBLE, please contact
the customer service center.
- Keep small parts and pieces away from children until fully assembled.
- Please check for any loose bolts and tighten them before you use.
TO AVOID DAMAGE TO YOUR FURNITURE.
-In storing patio furniture, do not stack anything on glass, stone or marble tabletops.
- If not drained properly, water can cause freeze damage.
- Cover furniture with outdoor furniture covers when not in use.
-For safety reasons, do not sit or stand on the table.

#D #E #F
Nut (M10) Qty:4
#G #H #I
Nut Wrench Qty:1
HARDWARE LIST:
Screw M10x680 Qty:4
Plastic Foot Cap Qty:4
Metal Washer Qty:4
Lock Washer Qty:4
2/7

STEP-BY-STEP ASSEMBLY:
STEP 1: Place table top (A) upside down on a non-abrasive surface.
Insert four screws (G) into each corner of the table top (A).
Slide the four legs (C) over the four screws (G).
Using the nut wrench (I), secure each leg with the metal washers (D), lock washers (E) and nuts
(F). Once the legs are tightened, cover the nuts with the plastic foot caps (H).
See illustration fig. 1
STEP 2: To extend the table size, pull the lever up .
fig. 2
1
2
3/7

STEP 3: Expand the table top to increase the length of the table.
Remove the stored panels from the shelf underneath the table top, fig 3.
STEP 4: Insert the panels in the middle of the table top as shown in fig. 4.
STEP 5: Slide the four panels together to lock in place, fig. 5.
4/7
3
4
5

STEP-BY-STEP ASSEMBLY:
STEP 6: To reduce the size of the table, reverse the procedure and store the extra panels on the
shelf underneath the table top, fig 6.
STEP 7: Push the lever down to lock the table into place fig 7.
6
7
5/7

QTY
A 1
B 2
C 4
D 4
E 4
F 4
G 4
H 4
I 1
Plastic Foot Cap
Nut Wrench
Lock Washer
Nut (M10)
Screw
M10x680
Table Rim
Table Leg
Metal Washer
Part descriptions
Parts image
Table Top
6/7

7/7