HealTech Electronics GIpro Mount User manual

GIpro Mount
Instructions manual
Choose the proper shim
Insert the pin Fasten the clamp
Disassemble the clamp. Separate the plastic shims
and unroll the thin shim. Depending on the target tube
diameter, select the corresponding shim and place on
the handlebar.
Slide the pin into place, making sure the threaded hole
is aligned with the bolt hole.
Tighten the bolt with an
M5 hex (Allen) wrench
to secure the clamp on
the bar in the desired
position.
Wind the arm around the handlebar then close.
If a plastic shim is used, rotate it to the correct
position.
Fully adjustable handlebar mount for GIpro
Place the clamp on the bar
Thick Thin
21-23mm (7/8”) : Thick Shim
24-26mm (1”) : Thin Shim
27-29mm (9/8”) : Without Shim

Cut the green foilMount the housing
Cut a small section of the green adhesive backing foil
as shown.
Place the housing in the desired orientation and
fasten the bolt. Try the display in the housing and
adjust the mount position if necessary.
Insert the GIpro unit into the housing, pushing it
firmly to the back to ensure good adhesion.
If you ever need to remove the GIpro from the
housing, use a small flat head screwdriver to lift it up.
Do NOT pull the cable!
Remove the smaller piece of the green plastic foil. Keep
the larger piece on the mounting tape.
Do NOT expose all the adhesive backing, otherwise
you will not be able to remove the display from the
mount later.
Remove the green foil Place the unit in the mount