Hear and Learn uconnect SoundHouse User manual

1/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
1. Flexmike and Sharemike paired to
Access Link inside SoundHouse
2. Output from AccessLink to Comms Box
for Music / Performance Audio Infra-
structure by Others. If the length of
cable from output of AccessLink to
Comms Box is less than 10m, use
general audio cable with 3.5mm male
plug to connect to from Access Link to
Comms Box. If length of cable is
greater than 10 metres, use CAT 5E/6
cable with Audio Extenders at each
end.
3. Output from Comms Box to Input on
ElectroBox inside SoundHouse. If the
length of cable from output of Access Link
to Comms Box is less than 10m, use
general audio cable with 3.5mm male plug
to connect to from Access Link to Comms
Box. If length of cable is greater than 10m,
use CAT 5E/6 cable with Audio Extenders
at each end.
4. Dependingonthesizeandcongura
tion of the space, a second Sound-
House may be required. Consult with
Hear and Learn.
UConnect SoundHouse by hearandlearn.com.au is a bespoke steel cabinet
complete with internal electronics, power supplies, labelling and signage for
capturing and delivering instructional audio in learning spaces.
There are two versions of the UConnect SoundHouse – our WALL MOUNTED
version and our RECESSED version. This document is relevant to installing our
RECESSED version which have a right angled rear body for easy install complete
withange.Itshouldnotwallmounted.
5. Braille Tactile signs provided by Hear
and Learn. These are compulsory and
mounted to these rules:
•Sign must be located not less than
•1200 mm and not higher than
•1600mmabovetheoororground
surface
•Located on wall on the latch side of
the door with the leading edge of
the sign located between 50 mm
and 300 mm from the architrave or
if this is not possible, the sign may
be placed on the door itself.
ThiscongurationofSoundHouseincludesourAccessLinkreceiver.OurFlexmike
and Sharemike are paired to the Access Link pre installed in the SoundHouse. These
microphones are charged and stored in the SoundHouse for convenient usage.
Your RECESSED SoundHouse is equipped with HEARING AUGMENTATION facilities. This
means forms of electronic Instructional Audio, PA, Screens – will be connected to the
SoundHouse making it available to people in these spaces who have receivers built in their
hearing aids.
See hearandlearn.com.au/hearing-augmentation-solutions
6. HearAssist includes local installation
 assistance,commissioningandsta
training.
7. Connection of power to GPO’s prebuilt
into SoundHouse. No wall GPO(s)
required.
400mm required
at mounting location
to allow access
600mm
required
at mounting
location
to allow
access 1000mm
fromoor
300mm
500mm
2
5
4
3
6
7
SOUNDHOUSE IS FOR EVERYDAY USE BY TEACHERS AND LEARNERS, BE UNOBSCURED, HAVE EASY ACCESS AND WITH LINE OF SIGHT OF AREAS OF THE ROOM.
hearandlearn.com.au
UConnect SoundHouse & Mini, 975 Point to Pair, Redcat Point to Pair & Topcat Point to Pair are part of the Hear and Learn technology family.
Oces Australia wide [phone]
1
Flexmike
Projector TV
Comms
Box
Second
SoundHouse
Sharemike
25mm
74mm
Speaker cable help
hearandlearn. com. au
/install
Gym speakers
By Others

2/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
There are two parts:
The SoundHouse and
the ange to cover the
gap between joinery/wall
and SoundHouse
The SoundHouse recessed-in-wall
model is designed for recessing
into a wall cavity.
NOTE: This requires carpentry which
stakeholders in this
project have been advised
about previously.

3/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
OUTPUT From Comms Box
OUTPUTS Cables to TransmitterTray
on the front of SoundHouse

4/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others

5/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others

6/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
DISCLAIMER*
Installer will be
responsible for
ensuring cavity hole
is cut out neatly so
unseen after ange
and SoundHouse
installed.
Door must protrude
by 45mm to allow
door to open freely
on box hinges
Slide the cover ange
onto SoundHouse Box
before xing box to wall
carpentry.
SoundHouse box
depth is 120mm.
It should be
recessed upto
90 mm but not
more to allow safe
operation of the
SoundHouse door.
hearandlearn.com.au/install
Cut hole in wall as per 1:1 scale
template link below
Download installation template at:
Template for recessing
Hear and Learn SoundHouse

7/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
Screw x Soundhouse box
to in wall carpentry.
Spacers may be required.
Distance between
right and left
spacer /stud
300mm
Screw x
through
cut outs on
both sides.
Hole dimensions
for pilot holes
in stud/spacer
300mm

8/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
Detailed stud
mounting hole
location

9/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
Precabling is to be completed prior to installation of
SoundHouse in accordance with electrical diagrams
for the project.
All SoundHouses require connection of power to inbuilt
GPOs in SoundHouse. Connection of power to SoundHouses
to be done by a registered electrician.
Other cables will require connection as per electrical
diagrams. These connections may include cable from PA
speaker, cable from AV systems and cables to speakers in th
learning space. *
SoundHouse has holes in its base for recessed installation.
*Note. Go to Point 2 on Page One for cabling length from AV
source to SoundHouse.
Power to internal GPOs
Cable from PA speaker
Cable from Comms Box of music /
performance system to input jack
on ElectroBox inside SoundHouse
Cable from Access Link in SoundHouse
to Comms Box of music/performance
system in space
25mm hole shown is to be used
for the power supply with an electrician
supplied conduit. The hole in the rear
of the box is not to be used when
SoundHouse is recessed into the wall.
25mm power
supply hole
NB. Connect 240v power to rst internal
preinstalled GPO and parallel cable to
two other internal preinstalled GPOs.
No extra GPOs required for installation.

10/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
Cable
Connection
If your SoundHouse has
Access Link/receiver/microphones
See speaker cabling instructions at
hearandlearn.com.au/install
Output from Access
Link to amp input
in Comms Box for
gym speakers

11/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others
Cable
Connection
If your SoundHouse has
Access Link/receiver/microphones
Cables to TransmitterTray
on the front of SoundHouse
OUTPUT
OUTPUTS
From Comms Box

12/12
Recess in Cavity
as an add on
to Music/
Performance
Audio Infrastructure
by Others