Heart of House HOH FRANKLIN 4112815 User manual

HOH4112815 V1
HOH FRANKLIN 6FT TREE
Assembly instructions - please keep for future reference 4112815
Important - please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
0345 640 0800

HOH4112815 V1
PRODUCT IS INTENDED FOR INDOOR USE ONLY
This product is not designed for permanent or long term use.
Do not use this product for any other purpose than its intended use.
Do not allow the product near/ contact with a source of heat or flame, e.g. gas or electric
heaters, fireplaces, candles or other similar heat sources.
Unplug the light chain (if any) when leaving the house, when retiring for the night, or if
unattended.
This product is for decoration use only. Not to be used by children as a toy and watch over
them when near the tree.
Ensure tree is stable, place on a firm and level surface, away from where it may be
knocked. And do not overload with excessively heavy decorations.
Artificial trees are made from small fibres and have small parts which may pose a choking
hazard detached from the branches. Keep out of reach of small children and pets
Retain the instructions for future use.
No tools required for assembly.
1. Check the pack and make sure you have all of the parts.
2. Remove all plastic bags and dispose of safely.
3. Decide on an appropriate location for your product, make sure that you have plenty of
space, a level surface and a clean dry area for assembly and locate. Always try to assemble
the product as close as possible to the intended location.
4. Choose a location where the tree is to be displayed. Take out the tree stand, pull apart the
legs of stand so that they are “X” shaped as Fig.1,place it on a flat surface.
5. Insert the pole with tapered end of the tree bottom into the tree stand and tighten the 3
screws on the stand.
6. Insert the middle tree section into the tree bottom and push down into position. The branches
are hinged and will fold down easily. As shown Fig. 2 & 3
7. Insert the tree top into the middle tree section and push down into position. As shown Fig. 3
8. Finally shape the tree by arranging the tips on the branches to give the desired effect. Some
tree styles have “side branches” attached to the main branch stem that require additional
shaping as shown Fig.4. After shaping the complete tree the finished look should be natural
and full.
Important
Instruction for use

HOH4112815 V1
Before using or re-using, inspect the product carefully. Throw away the products if any parts
damaged to cause the sharp point and edge.
Before storing the product, carefully remove the product from wherever it is placed to
avoid undue strain or stress on the product conductors, connections and wires.
If you’ve attached the light string to the tree, unplug it from the power supply and remove
the light strings from the tree.
Remove all decorations from the tree.
Gently lift off the top and middle section and remove the tree legs from the tree base.
Carefully place the tree in its box and tape it shut. STORE THE PRODUCT IN A COOL AND
DRY LOCATION PROTECTED FROM SUNLIGHT AND WHERE THE TEMPERATURE DOES NOT
EXCEED 40˚.
Maintenance
Made for Heart of House
489-499 Avebury Boulevard
Milton Keynes
MK9 2NW