HELLER BFH6 User manual

BFH 6
Instruction ManualInstruction Manual
100% Australian Owned Company

1.Name of parts1.Name of parts
1
PARTS AND FEATURESPARTS AND FEATURES
CabinetCabinet
ShelfShelf
Hinge CoverHinge Cover
DoorDoor
EvaporatorEvaporator
Thermostat Knob (at the rear)Thermostat Knob (at the rear)
GasketGasket
Adjustable LegsAdjustable Legs
Small DoorSmall Door
Door BarDoor Bar
77
88
99
11
22
33
44
88
55
66
77
99
1010
1010

2.Correctly positioning2.Correctly positioning
¡À¡À
¡À¡À
NN
Well Ventilating
Power Supply
Supply Cord
Protection from Moisture
It is necessary of good ventilation around the refrigerator for easy
dissipation , high efficiency of refrigeration and low power
consumption. For this purpose, it is a must to leave enough
clear space around the refrigerator. The back is at least 100mm
away from the wall, both sides at least have a space of 100mm
separately and the height from the top is not less than 200mm.
A clear space should be left to open its doors to 160.
heat
The refrigerator is only applied with power supply of single phase
alternating current of (220-240)V~50Hz; If fluctuation of voltage
in the district is so large that the voltage exceeds the above scope,
for safety sake, be sure to apply a.c. automatic voltage regulator
to the refrigerator. The refrigerator must employ a special power
socket instead of common one with other electric appliances.
Its plug must match the socket with ground wire.
The cord should be neither lengthened nor folded into
coil during operation. Moreover, it is forbidden that cord
is kept close onto the compressor at the back of the
refrigerator, the surface temperature of which is very
high during operating. Touching it would deactivate
the insulation or cause leakage for electricity.
Do not keep the refrigerator in a place where heavy
moisture is ,which can minimize the possibility of rusty
for the metal parts. Also, the refrigerator is forbidden to
be directly sprayed by water, otherwise, it is easy for
poor insulation and current leakage .

2.Correctly Positioning2.Correctly Positioning
Protection from Heat
Stable Fixing
Keep Away from Danger
Moving
Floor on which refrigerator will be placed on must be flat
and solid. It should not be layed on any soft material such as
foam plastic, etc. If the refrigerator is not on the same level,
please adjust the leg screws The refrigerator should not be
placed near anything which may echo.
It is inadvisable that the refrigerator is placed near
any volatilizable or combustible material such as
gas, petrol, alcohol, lacquer and banana oil, etc.
The above-mentioned objects can not be stored
in the refrigerator either.
When fixed or moved, the refrigerator can not be
set horizontally or declined to more than 45 or
upside-down.
The refrigerator should be far away from any heat
source or direct sunshine.

It must be checked that the voltage used is the same as the rated voltage before the refrigerator is
used.
Water contained in food or moisture in the air getting inside the refrigerator by opening doors may
form a layer of frost inside. It will weaken the refrigerator when the frost is thick. Therefore you
should defrost manually when the ice is thick. When defrosting, a pan is needed to put under the
evaporator to collect the defrost water.
Do not use any sharp tool to loosen or remove the ice as it may damage the evaporator or
refrigerator wall.
Do not use a hair dryer to speed up the defrost time.
If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed
by the manufacturer, because special purpose tools are required.
It is dangerous to alter the specifications or attempt to modify this product in any way.
When the refrigerator is not in use for long periods, disconnect it from the electricity supply.
Wait for 5 minutes before restarting the unit after a power supply blackout.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not operate any product with a damaged cord or plug, or after the product malfunctions, or is
dropped or appears damaged in any way. Return the product to the place of purchase for
inspection, repair or replacement.

55
4.Changing the reversible door4.Changing the reversible door
Before Reversing the door,the power must be shut off.
All parts removed must be saved to do the reinstallation of the door.
NOTE:
This refrigerator has the capability of either opening the door from the left
or right side. The unit is delivered to you with the door opening from the
left side. Should you desire to reverse the opening direction, please
follow these instructions.
This refrigerator has been built with the door hinges on the right. If you wish
to change the opening direction, follow the instructions below:
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the
frame. Take away the upper hinge (5).
3.Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws(8) that hold the lower hinge(2) and Make sure to
Remove the lower hinge(2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate(7) to the right side.
7.
Before placing this lower hinge(2), remove the bolt-pin (9) and reverse
the direction of the lower hinge(2). Then install the lower hinge (2) onto
the left side of the lower frame with two screws (8).
9. Set the door to its place making sure the door seat at the lower hinge(2)
.
10. While holding the door in the closed position secure the upper hinge (5) in the
top frame of left side with two screws (1). Please remember that do not tighten
the two screws(1) until the top of the door is levelled with the counter top.
1. Remove the upper hinge cover(6) first
8. Insert the bolt-pin(9) to the lower hinge (2).
11. Install the upper hinge cover(6) on the upper hinge..
44
8833
22
77
11
66
55
88
33
99
2244
77
11
66
55
Door opening fromleft side
Door opening from right side
99

66
The refrigerator should be cleaned and maintained once a month.
When performing maintenance, make absolutely sure that the power plug
is first disconnected from the power outlet.
Wipe the inner and outer surface of the refrigerator and its accessories with
wet cloth. If they are too dirty, scrub them with neutral detergent, and then
clean them with water and dry them with clean cloth. After this, a small
quantify of glass wax is recommended to polish the refrigerator surface with
a flannelette.
For cleaning, don't use hot water, diluent, petrol, alcohol, kerosene, washing
powder, cleanser, aikailinous detergent, acid, Chemical cloth, etc. So as not
to damage the lacquer coat and plastics. Do not spray the refrigerator
directly with water. Otherwise, it would cause rusty or weaken the insulation.
Be careful to upkeep the sealing rubber bars of the doors. They should always
be cleaned.
If the plastic parts in refrigerator remain contaminated for a long time by oil
(animal or vegetable), they will be easy aged and possibly cracked. The drain
pan gets dirty very easily if it is not cleaned regularly, bad odours will be produ-
ced, get into the habit of cleaning this pan regularly.
5.Maintenance5.Maintenance

7
6. Troubleshooting
Check if there is a power failure.
Check if the power plug is plugged into the power outlet.
Check that the fuse has not blown.
1. When the refrigerator does not work
The temperature control dial may be set too high.
If you place foodstuffs containing a lot of moisture directly under the cool
air outlets, they will freeze easily. This does not indicate a malfunction.
2. When the refrigerator is cooling excessively
The food may be packed too tightly together which will block the flow of cool air.
You may have put something hot or a lot of foodstuffs into the refrigerator .
The door may not have been closed properly.
The door gaskets may be damaged.
The refrigerator may not be ventilated.
There may be insufficient clearance between the refrigerator and the surfaces
The temperature control dial may not be set properly.
3. When the refrigerator is not cooling sufficiently
Condensation may form on the outside when the humidity is high such as during
a wet season. This is the same result as the condensation formed when chilled
water is poured into a glass. It does not, therefore, indicate a failure, wipe dry
with a dry cloth.
4. When condensation form on the outside of the refrigerator.
5. When you hear a sound like water flowing .
6. When the cabinet's side panel heats up
The side panel of the cabinet will heat up when the door is opened or closed
frequently, when starting the unit and when the unit operates in summer with
high ambient outside temperature, In such case, do not touch the panel, it
results from the dissipation of the heat from inside the cabinet, and it does
not mean that something is wrong with the refrigerator.
A sound like water flowing is the refrigerant flowing. It does not Indicate a
malfunction.

88
7.Technical specifications7.Technical specifications
*Specifications are subject to change without prior notice.
GAF Control (Sales) Pty. Ltd
18 28 Taras Avenue, North Altona,
Victoria 3025
Technical in home service number
1300 767 041
*For the detailed technical specifications, please refer to the nameplate at
the back of the refrigerator.