Henley Stoves Gemini User manual

Installation Manual
Gemini | Leo | Libra | Vega | Zodiac
EXCLUSIVE
Collection 2020
HENLEY
ST VES
EVERY HOME DESERVES A HENLEY

1
Exclusive
Collection
(1) The minimum safe distance of the
replace body to the wall is not less than
35cm, as shown in Figure 1. If the separation
distance is less than 35cm the wall must be
protected with a heat insulating material (re
bricks, marble, ceramic tiles, culture stone,
glass, metal plates etc).
The separation distance from the underside
of the replace to ground must be between
35 - 50cm. Please adjust this distance in
accordance with the situation on-site. The
vertical height of the chimney must not be
less than 4m.
An ash plate should be tted under the
replace, as shown in the illustration.

2
(2) Once you have conrmed the location in which your stove is to be installed, drill a 24-28cm
diameter opening in the roof to install the anges. The ange is xed with M12 expanding bolts
(bolt length not less than 10cm). Depending on the installation the ange can be installed on the
upper or lower part of the roof as shown in Figures 2 and 3.
(3) Adjust the chimney to the required length,
level the chimney and screw to the ange as
shown in Figure 4.
(4) Connect the rotation and axis damper to the
bar as shown in Figure 5. Adjust the angle of the
damper and tighten the screws.
(5) Seal the joint with high temperature resistant
sealant and screw the chimney in place as shown
in Figure 4. Fit the replace in position and tighten
screws as shown in Figure 5. Adjust the position
of the replace body and conrm that it can be
rotated forward and backward.

3
Exclusive
Collection
(6) Ensure that your chimney has been installed straight, level and xed into place.
Connect the rain cover and chimney, seal the joint with high temperature resistant
sealant and screw into place. The chimney, rain skirt, ange and roof joints should
be sealed with cement as shown in Figure 6. Ensure that there are no leaks and
check that everything is securely fastened. The installation is complete.
(7) If you have any issues with your installation please consult a professional
technician.

4
(8) Please refer to Figure 7 and 8 for installing on a pitched roof.
(9) Figure 9 shows the installation in roof
with false ceiling.
After completing Steps (1), (2), (3), install
the ceiling decoration ring (opening
diameter 28cm) as shown and complete
Steps (4), (5), (6).

5
Exclusive
Collection
(10) For wooden roofs a double stack
installation is required. Flanges and
chimneys are installed as per the
previous steps and an insulated ue
pipe is installed inside the ange. After
installing the rain skirt and rain cover,
seal the chimney and roof with cement
to make watertight.