hernest H200050 User manual

USER MANUAL
1
Caution
Please consu lt the professionals before installation or repairing. The company takes no liabilities for any damage or
injuries that occur during the installation of the pipes, floor, wall and tub.
Thank you for shopping with Hernest, please read this user manual thoroughly for your full under-
standing, installing, and application of the product. Please have this user manual well-reserved
for future reference.
Before Installation
Check the package and ensure that all parts are included. If any part is missing or damaged, please contact us.
Do not disassemble the main body, as it has been installed & commissioned correctly & precisely before leaving
the factory.
Shut off the main water supply before the installation.
Do flush the water supply lines to remove any dirt and debris before installation(IMPORTANT).
Make sure to connect the hot/cold inlet pipe correctly. If standing in front, usually the hot water pipe connects to
the left and the cold water pipe to the right.
Check for leaks and make sure every joint is safely sealed after the installation,
Turn on the water supply and flush the water pipes for 3 minutes to make sure it works well before putting it
into use.
SKU:H200050
Wall Mounted Bathroom Shower Set

Adjustable Wrench Hexagon Wrench
Philips Screwdriver Teflon Tape
2
1Fix the shower valve(A)into the wall, use
a level to ensure that the valve is straight
and level.
2Wrap Teflon tape around the pipe
threads and connect hot and cold water
supply lines and in-wall pipes(not
included) as desired to the valve. Turn
on the water supply and open the
cartridge to check for leakage. Then, put
on the protective cover.
Installation Steps
Tools You will need
Adjustable
Outlet1
Outlet2
Hot water inlet
Cold water inlet

3
For more detail information, please check out www.hernest.com
It will be our pleasure to have your visit.
After-Sale Service
If you have any issues with the product, please feel free to contact us online or by phone for customer service.
Phone No.: [phone]
Service E-mail: [email protected]
www.hernest.com
3Remove the protective cover when the
finished wall is completed and install the
escutcheon (B) to the valve (A) and press
it against the finished wall. Then, install
the handle (C) and diverter knob (D),
tighten the set screws (E) with Allen key
(F), and put on the indication buttons
(G).
4
6
Turn the water on for 1 minute to flush
any debris. Apply Teflon tape (H) to the
threaded tail-pipe and install the tub
spout (I) into the outlet on the wall.
5Apply Teflon tape (H) to the threaded
end, fix the cover plate (J) onto the wall
supply holder (K), and screw the wall
supply holder (K) into the hand shower
outlet.
Add rubber washers (L) at both ends of
the shower hose (M). Connect shower
hose (M) to the wall supply holder (K)
and hand shower (N). Then, place the
hand shower (N) to the wall supply
holder (K).
A
B
D
C
E
F
G
H
I
H
J
K
K
N
L
M