HeyGears UltraCraft AirCure ChairSide User manual

[email protected]Quickstart V1.3Follow us @HeyGearsUSA-17931 Sky Park Circle, Suite E, Irvine, CA, 92614CHN-Block B2, 501, 601, Enterprise Accelerator, Kaifa District, Guangzhou CityTel: [phone] (Global)/ [phone] (USA) / [phone] (EU)heygears.com[email protected]
ChairSide Curing Machine

NameModelSizeWeightUltraCraft AirCure310 x 300 x 245 mm6 kgInputUSB OutputPower100-240V～ @50/60Hz5 V 500 mA123 W1. Remove the model from the build platform, cut the support with nipper, then put water and model into the beaker.2. Models printed with Denture 2.0, Denture Teeth, Temp C&B 2.0 have to be cured with G reagent. Steps: Add G reagent to the beaker-Put model in and close the lid-Start curing with AirCure.Put in Water and Model2Cut Support1You can contact the after-sales and technical support staff via the following ways：1. After-sales support email address：[email protected]2. Available worldwide: [phone]. Europe: [phone]. USA: [phone]. Visit https://www.heygears.com/servicesMaintenance and Technical Support
5
STEP 1Plug the supplied power cord into the printer power port and turn on the switch next to it.Place the beaker with the model into the AirCure, close the lid and select the material by rotating knob, then press to start.*You can long press the knob for canceling.Remove the models when finished.STEP 2STEP 3STEP 4Plug the SuppliedPower Cord1Turn On the Switch2Close the Lid1
AirCurePower CordBeakerBrushBeakerDisplayKnobPower SwitchPower PortOpen the Lid1Remove Models2Rotate toSelect Material2Press Down toStart Curing3
Thank you for choosing HeyGears. For your safety, please follow the operating instructions. If you fail to comply with the instructions in this manual, HeyGears won`t be responsible for the consequential losses unless required by law.Please keep this operation manual properly for future reference. The pictures are for reference only and the products are subject to the actual product.Please read this installation andoperation manual carefully before useItems & Parameters
1
Overview
2
Installation Requirements
3
Place the product horizontally on a stable table before use.Make sure there is a 100V-240V power outlet nearby. Don`t open the lid during curing which will lead to stop.Beaker needs to be cleaned with brush regularly after finishing the curing.Operation Steps
4
Add G Reagent1Put Model2Close the Lid3UltraCraft PostCuring Unit