HI-ND ST551T-02 User manual

MANUFACTURER
HI-ND Sweden AB
Mekanikervägen 9A, 145 63 Tullinge
Email: [email protected]
INSTALLATION MANUAL
Part no: ST551T-02
SE Installationsmanual
GB Installation manual

IMPORTANT
Local installation rules must be obtained. A correct mounting is important and it is not the
responsibility of HI-ND Sweden AB. Faulty mounting may result in injury to persons. HI-ND
will not be responsible if the product has been mounted incorrectly. Expander bolts are not
included with the product. Properties and floor are specific for each case. Please make sure
the floor is straight and clean. Glue e.g PL600 can be used between the ground and the
bottom plate. Recommendation is to use below anchors
The Totem shall be fastened with 4 anchors in concrete. Follow below data for anchor type and
torque
h1: 7cm
Type: M10
Tinst: 50NM

1
.
Use
4 pcs of
10mm
anchors for the floor.
2.
Disconnect the
frontcover

3
.
Frontcover
disconnected
4
.
Connect
VESA
mount to the
backside of the
screen and attach the
display to the totem

5
.
Attach the
frontcover with a
screw below
6
.
Frontcover and
screen attached
7. T
otem use
angles
in each corner for
stability of the screen

8. Side
covers shall be
attached to the sides
9. Sideocovers a
re
attached to the
keyholes

10.
Computer can be
placed in the bottom.
11. Finished