High Road Wag'nRide Dog Barrier Frame User manual

A
A
A
B
B
B
2 x 2 x
Dog Barrier Frame Assembly
Pieces included:
2 - long “J” shaped rods with foam pad bumpers (A)
2 - short “J shaped rods with foam pad bumpers (B)
4 - webbed straps with buckles
1 - mesh barrier panel with side hook and loop
channels and bottom cord attachment
To assemble:
1. While pressing the spring lock down, insert straight end of rod A into curved end of rod B
until the lock clicks in place.
2. Repeat with remaining rods to form a rectangle (see diagram below).
3. Lightly pull on the rectangular frame to ensure rods are secure.
4. Lay the mesh panel flat with hook and loop side channels facing up.
5. Open the hook and loop channels, and place the metal frame so that the foam pads
are centered within.
6. Wrap the mesh channels around the foam pads and secure with the hook and look closures.
7. Buckle the webbed straps through all 4 corners of the frame.

Dog Barrier Frame Installation
To install: (best to do from the back seat of the vehicle)
1. Place the dog barrier between the 2 front seats with the metal frame at
the top, facing the windshield.
2. Buckle the lower corner straps around both headrest posts.
Adjust for a snug fit.
3. Buckle the upper corners straps vertically around the headrest.
Adjust for a snug fit.
4. Use the bottom cord attachment to secure the barrier by doing any of
the following:
a. Thread end of cord through an opening in the seat track, located
under the seat and on the floor of the vehicle. Loop it back around
and thread the end back through the 2nd opening in the cord lock
and pull tight for a snug fit. Repeat on the 2nd seat frame with the
other end.
b. Move the cord locks back on the cord to create enough length to
wrap each end around the 2 front seats. Thread the cord ends back
into the 2nd opening of the cord lock and pull tight for a snug fit.
c. Open the car console lid and wrap a long end of the cord around the
base of the lid. Thread the end back through the 2nd opening in one
cord lock and pull tight for a snug fit. ( Only 1 cord lock is needed.)
Care instructions: Wipe mesh clean with mild soap and warm water.
Common Sense Caution: While our poly coated mesh is tough and durable,
some dogs become very anxious in vehicles, and fabric material cannot be
guaranteed to withstand aggressive clawing and chewing. Do not use this
product if it is torn or damaged.
High Road Wag’nRide
is a division of Talus
Portland, ME 04103
www.highroadorganizers.com
ZS-HR-7227-BLK5X