HIK VISION DS-KAB671-P2 User manual

DS-KAB671-P2 Floor Stand Installation Guide
Hikvision Product Support Team
1
DS-KAB671-P2 Floor Stand Installation Guide
The stand is suitable for series:
DS-K1T671 / DS-K1T671TM-3XF / DS-K1TA70MI-T, in this document we take DS-K1T671TM-3XF for example.
For other models, we need to cut the built-in cable connector and connect to the face terminal cable.
DS-K1T981 /DS-K1T680 / DS-K1T673 / DS-K1T672 / DS-K1T341A / DS-K1T341BMI-T / DS-K1T342, etc, you can
contact our technical support for more information.
1. Prepare in advance
a. Prepare screw driver set (not included in the package)
b. open the package and you will find the stand and connector, screws, screw driver, etc
2. Remove the tape to loose the cable and pass the cable through the center hole in the base.

DS-KAB671-P2 Floor Stand Installation Guide
Hikvision Product Support Team
2
3. Screw in the nut from the bottom, use the wrench to tighten and lock, cables can be placed in the grooves on
the bottom
4. Hold the top part with left hand, and loosen the middle plastic adjustment handle with right hand to adjust the
telescopic tube to a suitable height, then lock the plastic part and the support rod assembly to fix the telescopic
tube assembly.
Note: The recommended height of the stand is between 106cm to 156cm.

DS-KAB671-P2 Floor Stand Installation Guide
Hikvision Product Support Team
3
Optional Step:
If you want to fix the base on the grand, please remove the 2 cover and fix the base with 2 expansion screw,
then install the cover back.
5. After adjusting the orientation of the bracket, fix it with the hexagonal screwdriver that comes with the
package

DS-KAB671-P2 Floor Stand Installation Guide
Hikvision Product Support Team
4
6. Fix the device back plate on the bracket with 4 screws, and connect network and other cables.
Note:
a. the back plate and face terminal are not included inside this stand’s package
b. Different model has different hardware interface, the cable maybe not compatible with all device models,
then you must cut the cable connector and connect to the face terminal cable
c. Different model of device backplate may be different, please select the appropriate screw hole.
7. Hang the device on the back plate and fix it with screws.
Note: Different model of device screw specifications and positions may be different, please choose a suitable
screwdriver

DS-KAB671-P2 Floor Stand Installation Guide
Hikvision Product Support Team
5
8. Connect the power cable to 12V 3A power adapter and network cable to the switch/router.
Appendix:
The relationship between stand height, recognition distance and identifiable face height
Height of
stand
Face Recognition distance
0.5m
1m
Min height of
person
Max height
of person
Min height
of person
Max height
of person
1.06m
0.99m
1.44m
0.93m
1.83m
1.56m
1.49m
1.95m
1.43m
2.33m

DS-KAB671-P2 Floor Stand Installation Guide
Hikvision Product Support Team
6
Note: The length of the built-in bracket is different for different device models, please adjust the stand height
according to the actual situation to obtain a better face recognition effect.