HIKOB GATEWAY H-GW103D-G User manual

Quick start guide
Document version 2017V2
This document may not be reproduced (even partially) or communicated
to 3rd parties without the written authorization of the company’s General
Management. Copyright © HIKOB.
Related HIKOB products:
WISECOW H-IS101A-T
WISECOW H-IS101A-P
WISECOW H-IS101A-W
GATEWAY H-GW103A
GATEWAY H-GW103D-G
LION H-RT101A
LIZARD H-AT200A

02/11/2016 • Page 2
Quick Start
Version 2017V2
1 Warning
HIKOB housings are not intended to be mounted or disassembled by the user. The complete
assembly is done by HIKOB or by a representative.
2 Commissioning
- Connect the HIKOB gateway to a PoE injector via an Ethernet cable.
- The HIKOB gateway is configured to obtain a dynamic IP address using DHCP.
But there is a specific IP configuration to access the HIKOB GATEWAY:
PC Configuration:
IP Address: 172.16.48.249
Subnet mask 255.255.255.248
The HIKOB GATEWAY can be accessed at: https://172.16.48.251
WARNING : to be able to reach the HIKOB GATEWAY this IP configuration must be
into a point to point connection (no router, no IP switch between the HIKOB
GATEWAY and the PC).
- Sensors and routers are autonomous, no action is required for their commissioning
3 Setting up the sensor network
Once the HIKOB gateway is switched on, the sensors will automatically connect to it. This
step can take up to 1 ½ hours because to save their battery, the sensors periodically scan
the radio space when not yet connected.
The reconnection to the HIKOB network can be accelerated by using a magnet to wake-up
the WISECOW sensors.
4 Web-based management and visualization interface
- The interface is accessible on the IP network to which the gateway is set, at the following
address: https: // {IP_passerelle_hikob}
- For the first connection to the HIKOB GATEWAY you must validate the security exception.
- The login is: "admin" and the password: "HiK0B**". 0 is a zero.
5 REST server
A REST server can be queried at the following address: https: // login: password @
{IP_passage_hikob} / URI