Warranty
Warranty malfunctions occurring under conditions of normal use in
conformity with the Instruction Manual and Product Precautionary
Markings will be repaired free of charge. This warranty is valid for a pe-
riod of three(3) years from the date of purchase. Please contact the
distributor from which you purchased the product for further informa-
tion on warranty provisions.
Introduction
Thank you for purchasing the HIOKI Model Z5000 Fixed
Stand.To obtain maximum performance from the product,
please read this manual first, and keep it handy for future refer-
ence.
Overview
The Z5000 stand is a fixed mounting bracket for the Hioki
LR8400-series Memory HiLoggers. It can be used as a desk
stand, or for panel wall mounting.
Inspection
• When you receive the product, inspect it carefully to ensure
that no damage occurred during shipping. In particular,
check the accessories. If damage is evident, or if it fails to
operate according to the specifications, contact your dealer
or Hioki representative.
Accessories:
Fixing metal (2pcs), M3x6 screw for Fixing metal (2pcs),
Supporting metal leg (1pc), M3x6 screw for Supporting metal
leg (3pcs)
• Before using the product the first time, verify that it operates
normally to ensure that no damage occurred during storage
or shipping. If you find any damage, contact your dealer or
Hioki representative.
Maintenance and Service
• To clean the product, wipe it gently with a soft cloth moist-
ened with water or mild detergent. Never use solvents such
as benzene, alcohol, acetone, ether, ketones, thinners or
gasoline, as they can deform and discolor the case.
• If the product seems to be malfunctioning, contact your
dealer or Hioki representative.
• Pack the product so that it will not sustain damage during
shipping, and include a description of existing damage. We
do not take any responsibility for damage incurred during
shipping.
Assembling the Z5000, and Setting the HiLogger
Z5000
FIXED STAND
Instruction Manual
Nov. 2018 Revised edition 3
Z5000A980-03 18-11H
EN
Wall mounting
Supporting metal leg will not be used. Surely fix the fixing
metals to the bracket. Mount the bracket to the wall by insert-
ing the M4 screws through the bracket mounting holes. (Fol-
lowing diagrams: mounting hole templates)
∗M4 screws are not supplied. Please use commercially
available M4 screws.
(Recommendable screw length: 8 mm or above)
Fixing metal
Bracket
1. Place the supporting metal leg on the backside of the bracket,
and insert the screws from the front of the bracket.
• To make it easier, fasten a screw tentatively at first.
• The stand angle varies depending on fixing way of the sup-
porting metal leg.
Supporting
metal leg
2. Place the HiLogger on the front of the bracket.
3. Put the projection of the fixing metal into the hole on the side
of the braket, and affix it using the screw. Do it on the other
side.
Inclination angle: 30 degree
Put the projec-
tion into the hole.
Backside
Front
Inclination angle: 50 degree
Backside
Front
M3x6
screw
M3x6
screw
2
3
3
150 (5.91”)
18
(0.71”)
10
(0.39”)
286 (11.26”)
Unit: mm (inch)
