Hisense MC086C User manual

MC086C user manual
Model: MC086C Mobile bracket
To ensure correct and safe use, please read this manual carefully before installation.
This model is suit for 55-86 inch smart board.
The maximum load of this support is 100KG.

1
M8×25 14pcs
1pcs
1pcs
4pcs
1
2
Materials List
A- The left leg 1pcs
B- The right leg 1pcs
D- The tray 1pcs
C- Hanging bracket 1pcs E- Wheel 4pcs
Other accessories (unit: mm):
Prepare for yourself
Prepare for yourself
M12 gasket
Hexagon head screw

2
2
2
A
B
E
FIG 1
Step 1: Adjust the wheel to the brake position and screw it into the leg.(Refer to figure 1) :
When turning on the wheel,
adjust the wheel to brake in
advance.

3
1
C
1
2
3
4
5
6
55"
65"- 70"
75"- 86"
FIG 2
Positive
Positive
Hole position
of bracket
Step 2: Attach the wall hanger bracket lock to one end of the leg.(Refer to figure 2)
Recommendations for the hole position of
hanging bracket
Adaptation model Matching hole position
Third and sixth holes
Second and fifth holes
First and third holes

4
1
D
1
FIG 4
Tighten all the bolts
Step 4: Assemble the tray between the two columns.(Refer to figure 4)
FIG 3
Step 3: Attach another leg lock to the other end of the wall hanger bracket.
(Refer to figure 3)
First insert the tray
into the positioning
bolts on the column.
Add the tray to the
positioning bolt.

5
Step 6: Hang the assembled whole machine on the wall hanging bracket and lock
the safety screw of the wall hanging bar.(Refer to figure 6)
Make sure the brakes are locked. At least 2 professionals are required
to complete this step.
FIG 5
FIG 6
Step 5: Lock the wall hangers on the whole machine according to the actual
requirements of the whole machine.(Refer to figure 5)

6
1
2. Hang the whole machine on the wall and lock the safety bolt
Positive
Positive
side of the wall
1. Lock the wall hanger panel on the
wall hanger bracket
Remark: In some cases, the built-in hangers of the whole machine cannot be effectively
matched to the foot rack, so the hangers need to be matched with the wall hangers.
The fitting process is as follows
Make sure the
unlocked floating
side of the wall
hanger is front

7
Step10: After the assembly effect, refer to the below picture.