Access the Internet
6
STEP On your connected computer or device, open a browser and
access a website, such as www.hitron-americas.com.
If you can see the website, your HT-EM2 is correctly set up!
Troubleshooting & Safety Warnings & Certifications
WARNING
Risk of electrical shock. Do not expose the device to water or moisture.
The device is a high-performance communications device designed for home and office environments.
Do not use the device outdoors. Keep the device in an environment between 0°C ~ 45°C (32°F ~113°F).
To avoid overheating, do NOT place any object on top of the device.
Do not restrict the flow of air around the device.
The manufacturer assumes no liabilities for damage caused by any improper use of the device.
DISCLAIMER
The manufacturer assumes no liabilities with respect to the contents of this document. The manufacturer
also reserves the right to revise this document or update the content thereof without any obligation to
notify any person of such revisions or amendments. Specifications subject to change without notice.
COPYRIGHT © 2015 HITRON TECHNOLOGIES, INC.
Use this section only if you were unable to connect to the Internet in step 6.
Problem: The LEDs do not turn on
If no LEDs turn on, check the HT-EM2 is plugged in to the power source correctly. If the POWER LED turns on, but the LINK LED
does not, wait up to 90 seconds. If the LINK LED remains off, contact your vendor. If the POWER and LINK LEDs turn on, but the
MoCA LED does not, ensure that the HT-EM2 is correctly connected to the building’s coaxial cable network, that the
MoCA-enabled router or network adapter is likewise correctly connected, and that it is switched on.
Problem: I cannot access the Internet
Ensure that you can connect to the Internet from a computer connected directly to your network’s MoCA-enabled router or
adapter.
Check the cabling connections between the router and your HT-EM2, and between the HT-EM2 and your computer (or, for WiFi,
ensure it is correctly connected to the network).
P/N:0440010190N0(2A)
Using the supplied Ethernet cable, connect your computer’s
network port to the HT-EM2’s LAN port.
The ACTIVITY LED turns on Green when the HT-EM2 detected a connection.
The ACTIVITY LED blinks when the HT-EM2 is actively sending or receiving
data over Ethernet.
The LINK LED turns on Blue when the HT-EM2 detected a 1000 Mbps
connection.
The LINK LED turns on Green when the HT-EM2 detected a 100 Mbps
connection.
Connect a computer to a LAN port
5
STEP
4
STEP
Connect a TV to the TV port (optional)
Using coaxial cable, connect your TV to the HT-EM2’s TV port.
