HMDX HX-P150 Instruction Manual

HEY THERE!
JUST CHARGE IT
WE’RE HERE TO HELP. CONTACT US!
HX-P150
Charging the speaker is so easy you’ve probably figured it out by now,
but just in case, you’ve got two options: you can charge it using your
computer or a wall outlet. The Clip-It needs about 3 hours for up to 4
hours of party time.
1. The cord that came with the speaker — the one with the USB on one
end and the micro USB on the other — will work with your computer.
2. If you want to use the wall outlet, you’ll need to pick up a power cord
with a micro USB the next time you’re at the store, or use any USB AC
adapter, including the one for your cell phone.
CONTROL YOUR DESTINY ... OR AT LEAST YOUR SPEAKER
BLUETOOTH®CONNECTION – IT’S A SETUP
1. That’s the power button.
2. Turn the music up or jam on to the
next song.
3. Push it to play, push it again to pause.
4. Turn the music down or skip back a track.
5. Shows you when Bluetooth is connected.
6. The power cord goes here.
7. Check how much juice is in the battery.
8. Clip it on and go!
9. Stand.
Like any amazing couple, this one starts with a connection — one between your
device and the speaker’s Bluetooth. Here’s how it works:
1. Make sure the smartphone, tablet, or computer you’re using with the speaker
has Bluetooth.
2. Turn on the speaker and look for the little blinking light.
3. Do whatever your device needs you to do on its end.
4. Look for HMDX Clip-It in your device’s Bluetooth list or click YES.
5. Now hit PLAY on your speaker and crank it up—or down if you’re lame.
The device and Bluetooth will find each other every time as long as the speaker is
set to Bluetooth and your device’s Bluetooth is, you know, on.
USA
[email protected]
1.800.753.3000
8:30am–7:00pm EST M–F
[email protected]
1.888.225.7378
8:30am–5:00pm EST M–F
CANADA
3s Bluetooth®
Devices
HMDX Clip-It
on
>
Thank you for purchasing the HMDX Clip-It. Check out the sections
below for all the important information about your new speaker.
USER GUIDE
AND WARRANTY INFORMATION
6
7
8
3
5
2
1
4
CLIP-IT
3h
You’ve got questions? We’ve got answers.
Contact a Consumer Relations representative by phone or email to help answer any questions.
Please be sure to have the model number of your product available. (Hint: It’s HX-P150)
Register your speaker! Information about where you bought it and how you’re using it is like
gold for the people who make these speakers.
USA: www.hmdxaudio.com/customer-support/product-registration
CAN: www.hmdxaudio.ca/product-registration
AC adaptor not included.
Continued on page 2.
SHED SOME LIGHT
Pairing Mode
Bluetooth Light Battery Light
Connected
Charging
Ready to Party
9

LITTLE BIT OF WATER?
HELLO? SPEAKERPHONE? YES!
BLUETOOTH®CONNECTION, CONTINUED
If you’re connecting to a computer, you may have some extra steps on that end.
You’ll have to get that information from the computer company.
Depending on your device, you may be prompted to enter a pairing code. If
prompted enter “0000” as the code.
To disable pairing of an existing device and pair a new device, press and hold the
+ and - buttons for 5 seconds to activate pairing mode.
Note: If you turn on your Clip-It but haven’t started the party yet, it will
automatically power off after 2 minutes of unpaired inactivity.
Note: Once you've paired, if you pause the party for 15 minutes or more, the
Clip-It will automatically shut off to preserve battery power.
2m 15m
No worries. The smart folks who made this speaker
designed it to keep the party going through just about
anything (they call it IPX4). But those designers aren't
miracle workers. Doing something like sending your
speaker for a swim in the deep end will fill those holes
you need for incredible sound with water. Remember
to keep the back flap flush with the speaker for the
best protection.
When friends call asking to join the party — and you know they
will—answer the phone without disconnecting from your HMDX
Clip-It. Yes, that’s right. Your speaker is a speakerphone too.
How amazing is that? Here’s how it works:
1. Make sure your phone and speaker are connected through
Bluetooth.
2. Answering and ending a call works the same way: simply click
the PLAY/PAUSE button on your Clip-It.
3. If you’d rather not talk, hold down the PLAY/PAUSE button on
your Clip-It for 3 seconds to ignore the call.
THE COOLEST PART: The Clip-It knows when a call is coming in
and pauses the music before ringing. When you hang up, the
music starts where it left off — and so does the party. If it’s you
making the call, just start dialing from your phone, and the
Clip-It automatically does its hands-free thing. Isn’t it refreshing
to know your speaker totally gets you?
Situation
Short Press Play/Pause Button Long Press Play/Pause Button
1st Incoming call
2nd Incoming call
On call
Both calls active
Pick up call
End call
Call 1 on hold, pick up call 2
Hang up call 1, switch to call 2
Reject call
Move call from speaker to device
Reject call 2
Switch between 1st call and 2nd call
Check out the chart below for a complete guide on handling calls with your Clip-It.
1 YEAR LIMITED WARRANTY
STUFF THE GOVERNMENT MAKES US SAY
FCC Disclaimer:
Note: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
For detailed warranty instructions and information visit:
USA: www.hmdxaudio.com/customer-support/warranty-1yr
CAN: www.hmdxaudio.ca/warranty-1yr
To obtain warranty service on your HMDX product, contact a
Consumer Relations representative by telephone or email for
assistance (you can find their contact info on page 1). Please
make sure to have the model number of the product available.
the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by HMDX could
void the user's authority to operate this equipment.
IC Caution: RSS-GEN Issue 4 November 2014
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions: (1) This device may
not cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
COMING CLEAN
A soft, dry towel is all you need to clean off
your speaker. Using water, harsh cleaners, or
anything else only starts messing with the
mechanics inside. So, yeah, don’t do it.

STUFF OUR LAWYERS MAKE US SAY A MESSAGE FROM THE ENVIRONMENT
IMPORTANT SAFEGUARDS:
When using an electrical product, basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
• WARNING: Do not place speakers too close to ears. May cause
damage to eardrums, especially in young children.
• Use this product only for its intended use as described in this
manual. Do not use attachments not recommended by HMDX.
• HMDX is not liable for any damage caused to smartphones,
iPod/MP3 players, or any other device.
• Do not place or store this product where it can fall or be dropped
into a tub or sink.
• Do not place or drop into water or any other liquid.
• Not for use by children. THIS IS NOT A TOY.
• Never operate this product if it has a damaged cord, plug, cable,
or housing.
• Keep away from heated surfaces.
• Only set on dry surfaces. Do not place on surface wet from water or
cleaning solvents.
Attention California Residents:
WARNING: This product contains chemicals known to the State
of California to cause cancer, birth defects, and other
reproductive harm.
WARNING:
This product has an internal, non-replaceable lithium battery. Please
dispose in accordance with your local, state, province, and country
guidelines.
This product contains small parts that may present a choking hazard for
young children.
CAUTION: All servicing of this product must be performed by authorized
HMDX Audio Service Personnel only.
©2015 HMDX. All Rights Reserved.
IB-HXP150 BC