
Assembly
Assembling the Reindeer and Sleigh
Step 1. Deer: Insert the metal rods attached to the each Leg (E&F) into the matching holes on the
underside of the Body (G) and fasten with the Plastic Ties (M). FIG.1
Step 2. The Legs come with metal bars attached to stabilize the Deer. Insert the hooked end of the metal
bars into the metal nut on the opposite Leg. FIG.1
Step 3.Insert the rod of Tail (H) into the rear of the Body. FIG.1
Step 4. Insert the Neck (D) into the matching holes in the front edge of Body (G) and fasten together with
Plastic Ties (M).
Step 5. Insert the Head (C) into the matching holes in the front edge of Neck (D) and fasten together with
Plastic Ties (M).Attach the Bow Decoration (P) to the Neck (D) of the Deer by running the wire tie
through the body material then twist the wire tie to secure. FIG.2
Step 6. Insert bothAntlers and Ears (A&B) into the matching holes at the top of Head (C). FIG.2
Step 7. Secure the Reindeer to the ground with the Ground Stakes (L). FIG.2
Step 8. Sleigh: Unfold each Side Panel (K) and Runner (J) of Sleigh. Insert the rods of the side of Panel
(K) into the matching holes of the Runner (J). Attach the Bow Decoration (P) to the Side Panel (K) of
the Sleigh by running the wire tie through the body material then twist the wire tie to secure.FIG.3
Step 9.The Runners come with metal bars to stabilize the Sleigh.Attach the bars to the opposite side
runner and fasten them with PlasticTies (M). FIG.4
Step 10. Unfold the Interior Panel (I). Insert the rods of the Interior Panel into the matching
hole at the each side of Side Panel (K). Fasten all components with Plastic Ties. FIG.5
Step 11. Secure the Sleigh to the ground with the Ground Stakes (L). FIG.6
Pre-Operation
CAUTION:Grasp the plug to insert or remove from the power source.
Do not unplug by pulling on cord.
CAUTION:The lighting string on this product is rated at 9.6 Watts
(0.08 Amps) for Reindeer and rated at 7.2Watts (0.06 Amps) for Sleigh. Do not
overload. Do not overload. Do not connect to other lighting strings, decorative outfit
or other electrical products. Before you use or re-use this product inspect it carefully.
Return to Store or discard if the product has cuts, damage or frayed wire insulation
on cords, cracks in the socket enclosures, loose connections or exposed copper wire.
CareandCleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any
undue strain or stress on the product, wire and lighting connections. If the product
is placed somewhere other than the ground it should be well secured and stable.
b. Wipe the unit with a damp cloth and allow the unit to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
FIG.1 FIG.2
FIG.3 FIG.4
FIG.5 FIG.6