Homebase FS40-3 User manual

INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before
using the product and retain for future use.
HHGL Limited, MK9 1BA
HHGL (ROI) Limited, D02 X576
16"
PEDESTAL FAN

2
SAFETY WARNINGS
Read this information carefully before installation or use of
this product. Keep this manual with the product for future
reference.
1. This appliance can be used by children aged from 8
years and above, and persons with reduced physical,
sensory or mental capabilities, or lack of experience
and knowledge, if they have been given supervision or
instruction concerning the use of the appliance in a safe
way and if they understand the hazards involved.
2. Children should not play with the appliance.
3. Cleaning and maintenance should not be undertaken by
children without supervision.
4. Children should be supervised to ensure that they do not
play with the appliance.
5. appliance is not in use.
6. Do not operate any appliance with a damaged power cord
or plug; if the appliance malfunctions; or if it is dropped
or damaged in any manner.
7. Do not use outdoors.
8. Do not use any appliance for anything other than its
intended use. This product is intended for household use
only.
9. This appliance is intended to be plugged in a standard
domestic power socket only.
10. Do not misuse the power cord. Never carry the appliance
by the power cord or pull to disconnect it from the
socket. Instead, grasp the plug and pull to disconnect.
11. Do not attempt to repair, disassemble or modify the
appliance yourself. There are no user-serviceable parts.
12. not be tripped over.
13. Do not insert or allow foreign objects to enter the grille
openings, as this may cause damage to the appliance
and/or injury to the user.
14. before removing the guard.

3
15.
16. Never use the fan without the guard. Do not use the fan if the
fan blade is damaged or cracked.
17. Do not leave hair, tissue, tablecloths, clothes or curtains
near any opening on the fan, they could be sucked into the
fan and taken within the internal moving parts, which could
cause injury or damage.
18. Do not use the fan in wet or damp locations such as
bathrooms.
19. Keep the fan away from pets.
20.Check the voltage indicated on the rating plate. This
product is designed for a 220-240V~ 50-60Hz electric
supply. Periodically check the power cord of this fan.
21. If the power cord is damaged, it must be replaced by
persons in order to avoid a hazard.
22.
23. Do not use this fan near a window or in direct sunlight.
24. Do not try to disassemble this fan; there are no
parts which can be repaired by the user. If you need
maintenance, please contact your local store.

4
TECHINCAL INFORMATION
Information to identify the model(s) to which the information relates to
Description
Model identifier(s): 647418
Maximum fan flow
rate
Symbol Value Unit
F 40,59 m3/min
Fan power input P 44,8 W
Service value SV 0,91 (m3/min)/W
Standby power
consumption PSB W
Fan sound power
level LWA 51,69 dB(A)
Maximum air
velocity C2,68
--
metres/sec
Measurement
standard
for service value
EN IEC 60879:2019
TECHNICAL SPECIFICATION
MODEL FS40-3
ARTICLE NO. 647418
WATTAGE 45W
WEIGHT 2.2kg
VOLTAGE 220-240V~
FREQUENCY 50-60Hz

5
ICON EXPLANATION
This appliance conforms to relevant directives of
The European Community.
The product complies with the applicable UK directives.
Class II appliance.
This marking indicates that this product should not be disposed
with other household waste. To prevent possible harm to
the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used appliance,
please use the return and collection systems or contact the
store where the appliance was purchased. They can take this
product for environmentally safe recycling.

6
PRODUCT STRUCTURE
4.
BODY ASSEMBLY
Loosen and remove the four screws (04) from the bar
A (13) and bar B (14). Then cross bar A (13) and bar B
(14) so that they interlock. Be sure to align the four
holes in the bars with the outer tube. Tighten the
outer tube to the bars with the four screws.
Loosen and remove the height adjustment control
collar (06) from the top of the inner pipe. Put the base
decorative cap (05) down to the base through the
tube inside.
Replace the height adjustment control collar (06) on
top of the inner pipe (03). Pull the inner pipe (03) out
from the outer tube to adjust the tube to the desired
height and tighten the collar.
Slightly loosen the switch rotate ring (07) by turning it
anti-clockwise. Put the switch box down over the
inner pipe and tighten the switch rotate ring.
Make sure it is tightly secured.
1.
2.
3.
01
02
03
04
05
06
07
08
09
Motor
Oscillation knob
Inner pipe
Screw
Decorative cap
Height adjustment
control collar
Switch rotate ring
Locking nut
Blade cap
Back safety grille
Fan blade
Front safety grille
Bar A
Bar B
Safety screw and nut
[12]
[11]
[09]
[08]
[10]
[03]
[07]
[01]
[06]
[05]
[13]
[14]
[04]
[02]
10
11
12
13
14
15
[15]

7
FAN GRILLE ASSEMBLY
Remove locking nut (08) by turning it anti-clockwise
from the motor shaft.
Place the back safety grille (10) into position. The slots
on the grille should align with the plastic rod on the
front motor cover. If this is done correctly, the safety
grille’s carry handle will be at the top.
Fix the back safety grille (10) into position by replacing
the locking nut (08) tighten by hand. Do not twist the
locking nut too hard.
The groove in the centre of the fan blade (11) aligns
with bolt on the motor shaft to ensure correct
positioning.
Fix the blade into the motor shaft gently by hand, and
tighten the blade cap (09) by turning anti-clockwise
onto the end of the motor shaft.
Mount the front safety grille (12) onto the back safety
grille (10), by hanging the top hook clip of the front
grille over the top of the back safety grille. Close the
clasps all around the grille, finally fit the safety screw
and nut (15) through the hole in the bottom edge of the
front grille and tighten.
1.
2.
3.
4.
5.
6.
OPERATION
Insert the power plug
Speed Control
Speed is controlled by the button switch.
(0=OFF, 1=Low, 2=Medium, 3=High).
To turn the fan on, press the desired button switch.
(1=Low, 2=Medium, 3=High).
Oscillation Control
To make the fan oscillate, push down on the oscillation knob (02)
located on the top of the motor housing. To stop the fan
from oscillating, pull up on the oscillation knob when the
fan is in the desired position.

8
CLEANING
Always unplug the fan before cleaning.
Use a soft damp cloth with a mild soap to clean the fan.
DO NOT use abrasive cleaners.
DO NOT immerse the fan in water and never allow water to
drop into the motor component.
DO NOT use petrol, thinner or other chemicals to clean
the fan.
1.
2.
3.
4.
STORAGE
–
Store the device and any accessories in a dry,
well-ventilated place.
–
In case of longer periods without operation, protect the
device and its accessories against soiling and corrosion.
Tilt Control
The airflow can be adjusted upward or downward by tilting
the fan head as desired.

9
PLUG REPLACEMENT
WARNING! The wires in the mains lead are coloured in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colour of the wire in the mains lead of this appliance
may not correspond with the coloured marking identifying
the terminals in your plug, proceed as follows:
The blue wire must be connected to the terminal marked N
or coloured black.
The brown wire must be connected to the terminal marked
L or coloured red.
WARNING! Never connect live or neutral wires to the
Connect Blue
to N (Neutral)
Outer sleeve
firmly clamped Cable grip
Brown L (Live)
Fuse
approved to
BS 1362
If you need to replace the fitted plug, then follow the
instructions below.
earth terminal of the plug. Only fit an approved BS 1363 or
BS 1363/A plug and correctly rated BS 1362 3 Amp fuse. If
in doubt, consult a qualified electrician.
NOTE: If a moulded plug is fitted and has to be removed,
take great care in disposing of the plug and severed cable;
it must be destroyed to prevent it being accidentally
plugged into a power socket.

10
This product is covered by a 2 year warranty.
The warranty covers any manufacturing defect in materials,
workmanship and finish.
Any claim under this warranty must be made by going to
your nearest Homebase store, taking your proof of
purchase with you, and claims must be made within 2 years
of the date of purchase.
We will offer you a free repair of the item where this is
possible, or a replacement or a refund. Your statutory rights
remain unaffected, in particular any rights you may have
under the Consumer Rights Act 2015.
This warranty is given by HHGL Limited, MK9 1BA; HHGL
(ROl) Limited, D02 X576
Please note: This warranty does not apply to products
misused or neglected and only covers domestic use. It does
not apply to commercial use of the product.
WARRANTY