Homebase FT-30MC User manual

12" CHROME EFFECT
DESK FAN
INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before
using the product and retain for future use.
HHGL Limited, MK9 1BA
HHGL (ROI) Limited, D02 X576

2
SAFETY WARNINGS
Read this information carefully before installation or use of
this product. Keep this manual with the product for future
reference.
1. This appliance can be used by children aged from 8
years and above, and persons with reduced physical,
sensory or mental capabilities, or lack of experience
and knowledge, if they have been given supervision or
instruction concerning the use of the appliance in a safe
way and if they understand the hazards involved.
2. Children should not play with the appliance.
3. Cleaning and maintenance should not be undertaken by
children without supervision.
4. Children should be supervised to ensure that they do not
play with the appliance.
5. appliance is not in use.
6. Do not operate any appliance with a damaged power cord
or plug; if the appliance malfunctions; or if it is dropped
or damaged in any manner.
7. Do not use outdoors.
8. Do not use any appliance for anything other than its
intended use. This product is intended for household use
only.
9. This appliance is intended to be plugged in a standard
domestic power socket only.
10. Do not misuse the power cord. Never carry the appliance
by the power cord or pull to disconnect it from the
socket. Instead, grasp the plug and pull to disconnect.
11. Do not attempt to repair, disassemble or modify the
appliance yourself. There are no user-serviceable parts.
12. not be tripped over.
13. Do not insert or allow foreign objects to enter the grille
openings, as this may cause damage to the appliance
and/or injury to the user.

3
14. before removing the guard.
15.
16. Never use the fan without the guard. Do not use the fan
if the fan blade is damaged or cracked.
17. Do not leave hair, tissue, tablecloths, clothes or curtains
near any opening on the fan, they could be sucked into
the fan and taken within the internal moving parts, witch
could cause injury or damage.
18. Do not use the fan in wet or damp locations such as
bathrooms.
19. Keep the fan away from pets.
20.Check the voltage indicated on the rating plate. This
product is designed for a 220-240V~ 50-60Hz electric
supply. Periodically check the power cord of this fan.
21. If the power cord is damaged, it must be replaced by
persons in order to avoid a hazard.
22.
23. Do not use this fan near a window or in direct sunlight.
24. Do not try to disassemble this fan; there are no
parts which can be repaired by the user. If you need
maintenance, please contact your local store.

4
TECHNICAL SPECIFICATION
MODEL FT-30MC
ARTICLE NO. 647420
WATTAGE 35W
WEIGHT 2.7kg
VOLTAGE 220-240V~
FREQUENCY 50-60Hz
TECHINCAL INFORMATION
Information to identify the model(s) to which the information relates to
Description
Model identifier(s): 647420
Maximum fan flow
rate
Symbol Value Unit
F 37,28 m3/min
Fan power input P 32,70 W
Service value SV 1,14 (m3/min)/W
Standby power
consumption PSB W
Fan sound power
level LWA 57,52 dB(A)
Maximum air
velocity C2,73
--
metres/sec
Measurement
standard
for service value
EN IEC 60879:2019

5
ICON EXPLANATION
This appliance conforms to relevant directives of
The European Community.
The product complies with the applicable UK directives.
This marking indicates that this product should not be disposed
with other household waste. To prevent possible harm to
the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used appliance,
please use the return and collection systems or contact the
store where the appliance was purchased. They can take this
product for environmentally safe recycling.

6
PRODUCT STRUCTURE
1
11
2 3
4
5
6
7
9
10
8
12
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Front grille
Fan blade
Rear grille
Motor
Oscillation knob
Control switch
Tube
Screw
Base
Base locking screw
Safety screw and nut
Screw
13.
14.
15.
16.
17.
18.
Post
Pivot knob
Neck retaining screw
Motor housing
Small adjustment knob
Large pivot bolt
NOTE: The illustration above
shows the motor housing
without the fan head. On the
fan model you purchased, the
fan head is already assembled
to the motor housing.
16
15 17
14 18 18
13
15
17
14 13

7
OPERATION
Set the fan on a level surface such as a table.
Put the plug into the wall socket.
Switch on the fan by turning the control switch on the
fan head.
a. Position ‘1’, the fan operates at low speed.
b. Position ‘2’, the fan operates at middle speed.
c. Position ‘3’, the fan operates at high speed.
d. Position ‘0’, the fan stops.
Loosen pivot knob (14) and small adjustment knob (17)
at same time. Then adjust the fan to desired angle.
Then tighten pivot knob (14) and small adjustment
knob (17).
The oscillation button is located on the head of the fan.
To start oscillation, push oscillation knob (5) down. To
stop oscillation, pull the oscillating knob (5) up.
1.
2.
3.
4.
5.
FAN GRILLE ASSEMBLY
Remove 4 pcs screw (12) by turning it anti-clockwise
from the motor (4).
Attach the rear grille (3) onto the motor (4) with four
screws (12).
Install the fan blade (2) onto the motor by tightening
the blade screw. Make sure the blade screw is tight-
ened onto the groove.
Centre the front grille (1) by aligning the locking safety
screw and nut (11) at the bottom hole hole of rear grille
(3) . Then secure the front and rear grille completely
together by snapping grille clips into place. Lastly,
tighten the grille safety screw and nut (11) at the
bottom of the rear grille (3) .
1.
2.
3.
4.

8
CLEANING
Always unplug the fan before cleaning.
Use a soft cloth, moistened with a mild soap to clean fan.
DO NOT use abrasive cleaners.
DO NOT immerse fan in water and never allow water to dip
into the motor component.
DO NOT use petrol, thinner or other chemicals to clean
the fan.
1.
2.
3.
4.
STORAGE
–
Store the device and any accessories in a dry,
well-ventilated place.
In case of longer periods without operation, protect the
device and its accessories against soiling and corrosion.
–

9
PLUG REPLACEMENT
Earth
(Green/Yellow)
Neutral
(Blue) Live
(Brown)
Fuse
WARNING! The wires in the mains lead are coloured in
accordance with the following code:
Blue - Neutral
Brown - Live
Green/Yellow - Earth
As the colour of the wire in the mains lead of this appliance
may not correspond with the coloured marking identifying
the terminals in your plug, proceed as follows.
The blue wire must be connected to the terminal marked N
or coloured black.
The brown wire must be connected to the terminal marked
L or coloured red.
The green/yellow wire must be connected to the terminal
marked or earth.
WARNING! Never connect live or neutral wires to the
WARNING! This appliance MUST be earthed.
If you need to replace the fitted plug, then follow the
instructions below.
earth terminal of the plug. Only fit an approved BS 1363 or
BS 1363/A plug and correctly rated BS 1362 3 Amp fuse.
If in doubt, consult a qualified electrician.
NOTE: If a moulded plug is fitted and has to be removed,
take great care in disposing of the plug and severed cable;
It must be destroyed to prevent it being accidentally
plugged into a power socket.

10
This product is covered by a 2 year warranty.
The warranty covers any manufacturing defect in materials,
workmanship and finish.
Any claim under this warranty must be made by going to
your nearest Homebase store, taking your proof of
purchase with you, and claims must be made within 2 years
of the date of purchase.
We will offer you a free repair of the item where this is
possible, or a replacement or a refund. Your statutory rights
remain unaffected, in particular any rights you may have
under the Consumer Rights Act 2015.
This warranty is given by HHGL Limited, MK9 1BA; HHGL
(ROl) Limited, D02 X576
Please note: This warranty does not apply to products
misused or neglected and only covers domestic use. It does
not apply to commercial use of the product.
WARRANTY