Homebase 636713 User manual

GBIN006632 148mm x 210mm
INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before using the product and retain for future use.
HHGL Limited, MK9 1BA; HHGL (ROI) Limited, D02 X576
6FT INFLATABLE
SANTA WITH SACK

Contents
• 1 x 6ft inflatable santa with sack
• 1 x power transformer
• 6 x stakes
• 3 x 1.8m ropes
Operating instructions
1. Unpack the inflatable and transformer from the box.
2. Ensure the zip on the base of the inflatable is fully closed.
3. Unwind the lead-in cable cord from the transformer and ensure
the weatherproof cap is tightened onto the transformer.
4. Choose where you want to locate the inflatable. If it is placed
outdoors, it is recommended to secure the inflatable as
detailed in point 5, to provide stability in windy conditions.
5. To secure, use the stakes provided and insert them through the
nylon hooks attached at the bottom of the inflatable. For the
nylon hooks attached to the inflatable body, use the provided
ropes and secure them to the stakes firmly. The recommended
angle for the ropes is 30º- 45ºfrom the top, as this provides a
stable condition for the inflatable.
6. If additional stability is required, sandbags (not supplied) can be
placed into the zip compartment on the base of the inflatable.
7. Plug the transformer supplied with this kit into a mains socket
outlet and turn the main switch ON.
8. The inflatable will inflate to the correct size within a few
minutes. If it is not inflating, it is possible that the passage
from the fan to the inflatable is obstructed. Turn the adaptor
OFF and adjust if required.
Caution
• Do not put your hands over the fan whilst it is inflating.
• Do not attempt to put any small objects through the
fan grille.
• Do not attempt to inflate this unit during extreme weather
conditions, for example strong winds, heavy rain/snow, cold
temperatures lower than -10 degrees. Turn OFF the inflatable
and bring it indoors.
• If a child is near the inflatable, it must be under the full
supervision of an adult.
Maintenance and cleaning
• Only use mild detergent with cold water to wipe.
• Leave it inflated until it is completely dry.
• To store the inflatable away, make sure to unplug, roll up and
store in the original packaging.
• Do not attempt to open the air blower.
Repair
• If the festive figure is not staying inflated even when the fan
is working at full power, it is likely that there is a hole or tear in
the inflatable.
• Locate the source of the puncture, turn the festive figure ON
and examine the holes or tear.
• Small holes can be patched up with tape. A thick clear
packaging tape will work, as well as duct tape (not supplied
with this kit).
• If the tape is not strong enough or holes are especially large,
use a nylon patch. These patches can be obtained from your
local arts and crafts stores.
• Once the hole has been sealed, re-inflate the festive figure
and check.
Warning
Please read through the instructions and warnings before use.
Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
• The transformer reduces mains voltage from 240V down to a
safe low operating voltage. Please note that if the inflatable
is used outdoors, the transformer must be kept under proper
shelter or plugged in a suitable weather protected power
outlet. During snowy seasons, ensure the adapter has proper
clearance from the snow.
• Always unwind the cord fully before use.
• Always use the transformer that came with the kit to operate
it. An incorrect transformer can damage the fan and LED
inside.
• This product is intended as a Christmas decoration only, it is
not to be used by children as a toy and is not intended for
household illumination.
• Do not connect the product to the power supply while the
product is in the packaging.
• Retain the packaging for storing the unit when not in use and
keep this information for future reference.
• Unplug when not in use. Always unplug from the mains supply
whilst installing, carrying out maintenance or adjustment.
• The external flexible cable or cord of this light chain cannot
be replaced; if the cord is damaged, the light set must be
destroyed.
• If you use an extension cable/cables, use one that is the right
length for your needs. Do not chain several cables.
• Do not attempt to modify the wiring or ‘cut to length’.
• Keep out of the reach of children.
• Small parts could pose a choking hazard.
• This product is NOT designed for permanent or long term use.
Disposal and recycling
Electrical products are labelled with the wheelie bin symbol to
indicate that they are to be collected and recycled at end of
life. Users of electrical products should not dispose of them as
unsorted municipal waste but use the separate collection facilities
available. Check with your local authority for recycling advice.
Customer participation is encouraged to minimise any potential
effects on the environment and human health from the potential
presence of hazardous substances.
GBIN006632 148mm x 210mm
Product Specification
Overall Dimensions H180 x W100 x D65cm
Overall Wire Length 5m
Transformer IP44, Output 12V DC Max. 8.4W
Light 1 LED bulb
Inflate Time 60 seconds
The packaging material is recyclable.
Dispose of the packaging in an
environmentally safe manner and make
it available for the recyclable material
collection-service.
transformer
light set
IP44
Dispose of the product in an
environmentally safe manner when
you decide to part with it. This device
should not be disposed of with
household waste. Dispose of it at a
recycling centre, check with your local
authority or store for recycling advice.
Please note that all products with this
symbol must be recycled.
GBIN006632
Made in China