Honey Can Do WRD-01272 User manual

WRD-01272
WRD-01518
60" wide double door
storage closet
64 in H x 60 in W x 19.7 in D (163 cm H x 152.4 cm W x 50 cm D)
www.honeycando.com | [e-mail] | 877.2.I.can.do (877.242.2636)

IMPORTANT! Plead read prior to use. This Honey-Can-Do 60 inch Wide Double
Door Storage Closet is designed for indoor use. Please do not over-load. To prevent
tipping, we recommend that you evenly distribute the weight throughout the unit.
Please keep top hanger bar horizontal when in use. Please do not use storage closet
for anything other than its intended use. Please do not allow children, husbands or
pets to hang from or hide in storage closet. Please keep away from heat sources
such as heaters and fireplaces.
2

PARTS LIST
PART/ILLUSTRATION (QTY) DESCRIPTION
Thank you for purchasing a Honey-Can-Do Storage Closet!
Please follow these step by step instructions carefully. Plan
to spend about 35 minutes assembling your new closet. For
assistance, please contact us at [email protected] or
877.2.i.Can.Do. Your closet will hold up to 50lbs when hangers are
evenly distributed across the unit.
(5) support bars
(5) tapered supports bars
(12) uprights
(1) cover
F
(1) hang bar
(1/8" thicker than support bar)
H
(1) tapered hang bar
(1/8" thicker than support bar)
G
E
3
(6) side supports
(3) middle supports
(these holes pass all the way through support)
(these holes Do Not pass all the way through support)

LOWER FRAME ASSEMBLY
ASSEMBLY
1. Insert the end of 2 support bars (E) into left side support (A).
2. Take one middle support (B) and slide it on to the other end
of side supports (E) from step one.
3. Insert the narrow end of 2 tapered support bars (C) into the
exposed ends of support bars (E) from step 1.
4. Place another side support (A) onto exposed ends of tapered
support bars (C) from step 3.
5. Insert 6 uprights (D) into the tops of the side and middle
supports (A & B).
Note: all of the poles will need to be firmly seated into the plastic
support pieces. DO NOT ROCK or TIP poles back and forth. Only
push with firm even pressure straight into plastic support pieces.
Please follow steps in the order
listed. You will be working from
your left to right.
A
A
B
E
E
C
C
D
D
D
D
D
D
Lower Frame Assembly
4

PLACE COVER ON LOWER FRAME
ASSEMBLY
Please note: that this lower frame will be on the outside of the cover
while the rest of the unit will be inside the cover.
1. Unzip the cover (F) all the way and carefully feed the lower
frame uprights (D) through the holes (they are small slits) in
the bottom of the cover. You must continue working inside
the cover while you finish constructing the rest of the closet.
F
5

STEP 1 (LOWER FRAME)
ASSEMBLY
WORKING INSIDE
ASSEMBLY
Working inside the cover continue by building the middle
frame on top of the lower frame. Let the cover rise above the
base unit 10-15 inches so that you have room to maneuver when
working inside the cover.
6

STEP 1 (LOWER FRAME)
ASSEMBLY
MIDDLE FRAME ASSEMBLY
ASSEMBLY
what you should have so far...
Working inside the cover
1. Install two side supports (A) and one middle support (B) on top of the
uprights (D) from the lower assembly.
2. Insert the end of 1 support bar (E) on the back of left side
support (A).
3. Slide middle support (B) on to the other end of side support
(E) from step two.
4. Insert the narrow end of 1 tapered support bar (C) into the
exposed end of support bar (E) from step 1.
5. Take exposed end of tapered support bar (C) from step 4 and
slide it into back of remaining support (A).
6. Insert remaining 6 uprights (D) into the tops of the side and
middle supports (A & B).
A
A
B
E
C
D
D
D
D
D
D
Middle Frame Assembly
Lower Frame Assembly
7

TOP FRAME ASSEMBLY
ASSEMBLY
Working inside the cover
1. Install two side supports (A) and one middle support (B) on top of
the uprights (D) from the middle frame assembly.
2. Insert the end of 2 support bars (E) into left side support (A).
3. Insert hanger bar (H) in the BOTTOM center hole of left side
support (A) see inset above.
4. Slide middle support bar (B) on to the exposed ends of
support bars (E) from step 2 and hang bar (H) from step 3.
5. Insert the narrow end of 2 tapered support bars (C) into the
exposed ends of support bars (E) from step 2.
6. Insert narrow end of tapered hang bar (G) into exposed end
of hang bar (H).
7. Insert exposed ends of tapered support bars (C) from step 3
and hang bar (G) from step 6 into right side support (A).
A
A
hang bars (H) & (G) are
placed into the bottom
holes of the plastic
supports
B
C
H
C
E
G
E
Middle Frame Assembly
8

FINAL STEP!
ASSEMBLY
1. Gently pull cover down so that the bottom meets the base.
Align the cover corners with the frame corners.
9

FINISHED PRODUCT
ASSEMBLY

LIMITED LIFETIME WARRANTY
Honey-Can-Do International, LLC (HCD) warrants its products will be free from defects in ma-
terials and workmanship when used for normal personal or household use, except as provided
below. HCD, at its option, may offer a comparable product or offer a replacement part or
request that the item be returned to the place of purchase. This warranty DOES NOT apply to
damage caused by negligence, misuse, excessive use, improper cleaning, improper assembly,
or any circumstances not directly attributable to manufacturing defects. Proof of purchase
is required in the form of a receipt (copy or original) to validate warranty. HCD provides this
limited lifetime warranty in lieu of all other warranties either express or implied. In no event
shall HCD, its affiliates, or subsidiaries be responsible for consequential or incidental dam-
ages arising out of a claim of defective product. Some states or provinces do not allow some
exclusions or limitations, so the above statement may not apply to you. This warranty gives
you specific legal rights, and you may also have other rights, which vary by state or province.
WARNING: Keep bags and plastic sheeting away from babies and children. Do not use in cribs,
beds, carriages, or playpens. The plastic may cling to nose and mouth and prevent breathing.
PLEASE RECYCLE

Honey-Can-Do International
5750 McDermott Drive, Berkeley, IL 60163 USA
877.242.2636 | www.honeycando.com
©2011 Honey-Can-Do International, LLC | All Rights Reserved
your source for
organization,
storage & style
120607