(“To apply water-base wax” cont.)
are packed with each kit.
To apply without dispenser, follow directions below.
On all floors, except wood or cork, pour wax on floors in
2 inch pools spaced at 2 foot intervals in a small area so
the wax can be spread quickly. Do not allow the wax to
remain on the floor in pools. The polisher will spread the
wax quickly and evenly. Let wax dry thoroughly before
polishing. While wax is drying, tip the polisher back on
the handle so the brushes will dry.
To apply to sealed wood or cork floors, do not pour wax
on floor. Apply from dispenser or’pour wax in pan and
spread with a wax applicator.
TO APPLY SOLVENT-BASE WAX To apply liquid polish-
ing wax, pour wax on floors in 2 inch pools spaced at 2
foot intervals in a small area so the wax can be spread
quickly and easily. Guide polisher in straight lines or with
the grain of the wood until wax has been rubbed into the
floor. Let wax dry thoroughly before polishing.
To clean floors with liquid polishing wax, apply wax to
the floor as above and use steel wool pads or Cleaning-
Waxing Pads* on the brushes. Steel wool pads can be made
from fine steel wool, 00 grade. Cut steel wool in 4 inch by
4 inch squares and press pads firmly into bristles of
brushes. Use one set of pads for cleaning approximately
4 feet by 6 feet of floor space. Cleaning-Waxing Pads*
snap on the brushes. Both sides of the pads can be used.
When cleaning large areas or very dirty floors, if pads no
longer pick up the dirt, they should be washed (see page
To apply paste wax, spread wax
on brushes or spread small
amount on floor with spatula.
Apply to the floor by guiding
polisher in s’traight lines or with
grain of wood until the wax is
spread thinly and evenly. Add
more wax as needed. Let wax dry
thoroughly before polishing.
” Accessory. See page 9.
6
