Hougen 05536 User manual

A
A
B
1
The 05536 Adapter Kit is to be used to install a Jacobs Chuck(sold separately) onto a "Hex Drive" spindle. The
Hex Drive Assembly will have 2) 1/4-28 X 3/8 set screws (Fig.1) at the top of the arbor body. If your HMD904 or
HMD908 does not have these set screws the Arbor Assembly is a Threaded Spindle and will require the use of
Spindle Adapter 01829.
Remove the set screws (A) from the top of the Arbor Body and the Front Support Bracket Bolts (B) from the front of
the Magnet. Once these are removed the Arbor Body Assembly can be removed from the Drill Assembly.
1
23
45
Thread the 3-Jaw Chuck onto the Spindle Adapter until tight. Now slide the complete assembly up onto the Hex
Spindle at the bottom of the motor. While pushing up on the Spindle Adapter / Chuck Assembly, turn the set screw
in at the top of the Adapter until tight; as shown in Fig.5.
Continued
Chuck sold separately
SPINDLE ADAPTER KIT 05536
For use on Hougen Drill Models HMD904, HMD908 & HMD925

MOTOR
(05536) SPINDLE ADAPTER KIT
Set-Screws
Hex Adapter
Approx. 1.188”
Approx. 2.38”
Approx. 5.875” when the drill motor
is in the UP position with 4” of stroke down. Magnet
Drill Chuck
Your 3-Jaw Chuck is now installed. Select the proper twist bit for your application and follow Operating Proce-
dures for the Hougen Magnet Based Drill you are using.
640432 Stop Screw SHC 1/4-28 X 3/8 to use with the HMD904 or HMD908.
05357 Stop Screw SHC 1/4-28 X 7/8 to use with the HMD925.
Now that the Chuck and Adapter is installed, part number
40432 Stop Screw needs to be installed on the HMD904
& HMD908 or install the 05357 on the HMD925. This Stop
Screw sould be threaded into the top of housing in front of
the Motor Assembly as shown in Diagram 6.
Chuck sold separately
Hougen Manufacturing, Inc.
P.O. Box 2005 • Flint, MI 48501-2005
3001 Hougen Drive • Swartz Creek, MI 48473
Phone [phone] • Fax [phone]
www.hougen.com • [email protected]
© 2019 Hougen Manufacturing, Inc.
FORM 05547