HP Compaq NX9008 User guide

Startup Guide
HP Compaq Notebook Series
Document Part Number: 333953-001
August 2003
This guide explains how to set up your hardware and software, locate
and install the latest versions of HP software, and locate additional
information and support. This guide also introduces you to exterior
features of the notebook.

© Copyright 2003,2004 Hewlett-Packard Development Company, L.P.
Microsoft and Windows are trademarks of Microsoft Corporation in the U.S.
and/or other countries. SD Logo is a trademark.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should be
construed as constituting an additional warranty. HP shall not be liable for technical
or editorial errors or omissions contained herein.
Startup Guide
HP Compaq Notebook Series
Reference Number: nc8000/nw8000
First Edition August 2003
Document Part Number: 333953-001

Contents
1 Hardware and Software Setup
Setting Up the Hardware ............................................................... 1–1
Setting Up the Software................................................................. 1–5
Installing Optional Software ................................................... 1–6
Selecting Regional Settings .................................................... 1–7
Selecting Screen Settings........................................................ 1–8
Setting Up Wireless LAN ....................................................... 1–8
Setting Up Bluetooth............................................................. 1–10
Safeguarding the Notebook ......................................................... 1–11
Protecting the Notebook Against Viruses............................. 1–11
Turning Off the Notebook .................................................... 1–11
Using the Notebook Safely.......................................................... 1–11
Regulatory and Safety Information ............................................. 1–12
2 Additional Information, Help, and Updates
Using the Documentation Library CD .......................................... 2–1
Getting Help .................................................................................. 2–3
Using the Help and Support Center in
Windows XP ........................................................................... 2–3
Contacting Technical Support................................................. 2–4
Installing a Retail Version of an Operating System ...................... 2–6
Startup Guide iii

Contents
3 Notebook Features
Pointing Device Components ........................................................ 3–1
Top Components ........................................................................... 3–2
Lights............................................................................................. 3–5
Left Side Components ................................................................... 3–7
Right Side Components................................................................. 3–9
Front View Components.............................................................. 3–11
Rear Panel Components .............................................................. 3–12
Bottom Components.................................................................... 3–14
Labels .......................................................................................... 3–16
Index
iv Startup Guide

1
Hardware and Software Setup
WARNING: This notebook is designed to run demanding
applications at full power. As a result of increased power
consumption, it is normal for the notebook to feel warm or
hot when used continuously. To avoid potential discomfort
or burns, do not block the air vents or use the notebook on
your lap for extended periods. The notebook complies with
the user-accessible surface temperature limits defined by
the International Standard for Safety of Information
Technology Equipment (IEC 60950).
NOTE: Because of limitations in current TFT manufacturing
technology, TFT displays may show imperfections as bright,
dim, or dark spots. HP does not guarantee that TFT displays
are free from such imperfections.
NOTE: For governmental agency and safety information, refer
on the Documentation Library CD to the Regulatory and Safety
Notices.
Setting Up the Hardware
CAUTION: To ensure that the correct drivers load and to prevent
file corruption or damage to the components during initial setup:
Do not set up the notebook while it is docked in an optional
Port Replicator.
Do not remove the battery pack until the notebook has been
connected to external AC power.
Run the notebook on external AC power, not on battery
power, throughout initial setup.
Startup Guide 1–1

Hardware and Software Setup
To set up the notebook:
1. Slide the primary battery pack into the battery bay until
it is seated.
NOTE: If you will not be using the notebook for 2 weeks or
more, removing the battery and storing it will prolong its life.
For more information, refer on the Documentation Library CD
to the Hardware Guide, “Battery Packs” chapter.
1–2 Startup Guide

Hardware and Software Setup
2. Connect the notebook to external AC power:
a. Place the notebook on a flat surface near an electrical
outlet.
b. Connect the AC adapter cable 1to the power connector
on the notebook.
c. Connect the power cord 2to the AC adapter.
d. Plug the power cord 3into an electrical outlet. (Power
cords and outlets vary by country.)
Startup Guide 1–3

Hardware and Software Setup
3. Open the notebook by pressing the display release latch 1
and lifting the display 2.
4. Turn on the notebook by pressing the power button.
1–4 Startup Guide

Hardware and Software Setup
After the notebook powers on:
The power/standby light turns on. (See “Lights” later in this
guide for more information.)
The battery pack in the battery bay begins to charge, and the
battery light turns on. (The battery light remains on while
the battery pack is charging and turns off after the battery
pack is fully charged. See “Lights” later in this guide for
more information.)
The software setup prompt displays on the screen.
Setting Up the Software
A prompt to set up your software displays on the screen when
the notebook is turned on for the first time. Before responding to
the prompt and proceeding through the onscreen instructions, read
the following caution and other installation information contained
in this chapter.
CAUTION: To prevent file corruption and to ensure that the correct
device drivers install, follow these guidelines during software
setup:
Do not unplug the notebook from the electrical outlet.
Do not shut down the notebook.
Do not remove or insert a drive.
After you begin the software setup, you must complete the
entire process without interruption. Setup time varies.
If you are prompted to select a language, choose carefully.
The languages you do not choose are deleted from the system
and cannot be restored once the setup process has begun.
If you are prompted to accept the End User License
Agreement, you must choose Accept to continue the
software setup.
Startup Guide 1–5

Hardware and Software Setup
Preloaded software applications are included with the
notebook but must be installed through the Software Setup
utility. Preinstalled software applications have already been
installed on the notebook and require no further installation
procedures.
This guide does not take into account any variation that may
result from the notebook being connected to a network.
This guide documents the Windows® 2000, Windows XP®
Professional, and Windows XP Home operating systems.
Any other operating systems installed on this notebook after
purchase may not match the descriptions and procedures
provided in this guide.
This guide documents the category view that is used by
default in Windows XP. If your notebook is set to classic
view, you may notice discrepancies between your notebook
and this documentation. For information on switching views,
see Windows XP Help and Support.
Installing Optional Software
You can install third-party software or preloaded utilities any time
after initial setup is complete.
To install third-party software, refer to the documentation
included with the software.
To install a preloaded utility:
In Windows 2000, select Start > Programs > Software
Setup.
In Windows XP, select Start > All Programs > Software
Setup.
A setup wizard loads and a list of applications displays. Select
the application you want to install and follow the instructions on
the screen.
1–6 Startup Guide