HUANUO HNPS01 User manual

Model:HNPS01
3 TIERS PRINTER RACK
INSTRUCTION MANUAL 2
Thank you for choosing this HUANUO product! At HUANUO
we strive to provide you with the best quality products and
services in the industry. Please share your experience of our
product with others at www.huanuoav.com/reviews if you
are satisfied. Should you have any issues, please don't
hesitate to contact us.
Technical Support:
1-800-556-0533 Mon-Fri 10am - 5pm (PST) (USA) (CAN)
Other Info:
[email protected] (US/CA)
Website:
www.huanuoav.com

Supplied Parts
A X2 B X1 C X4 D X16 E X4
Wire Shelf Wooden Board Pole Plastic Clip Nylon Caster
Wrench
Screw Nylon Casters [E] into the bottom of four Poles [C] by wrench.
Snap one pair of Plastic Clips [D] on the same groove of each pole as
shown in the below image. The arrow of all plastic clips should be
pointed up, and the grooves of pole should be covered by convex part of
plastic clips.
Grooves of Pole Convex Part of
Plastic Clips
Step 1
D
C
E

Step 3
Step 2
Keep the collar of the Wire Shelf [A] downward. Then slide the Wire Shelf
[A] into the plastic clips from the top of each poles.
Keep the collar downward
Set the shelf upright. Refer to Step 1, 2 to snap the plastic clips [D] on
the same grooves of each poles at your desired position for the second
wire shelf [A]. Then refer to Step 2 to assemble the second wire shelf [A].
DA
C
A
C
D

Step 4
Insert the plastic parts under the Wooden Board [B] into the top of the
four poles to make it snug on the poles. Push firmly down the corners
of the two wire shelves [A] by rubber mallet (not included) to make the
wire shelf [A] secure onto the plastic clips. Now the three tiers printer
rack is completely assembled.
NOTE: Put fabric between rubber mallet and shelf to prevent damage.
B
C
Mallet