HUBBARDTON FORGE DESIGN 272865D User manual

Glass Installation Instructions C73
Disq Table Lamp 272865D Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 32775
Figure 1
To Install Shade & Diffusers (Figures 1 thru 3)
Component Parts
ATop Diffuser
BShade
CBottom Diffuser
DThreaded Nipple
EFixture
FFinial
1. Carefully unpack the lamp from the carton.
2. Place top diffuser (A) on a flat surface.
Note: An additional person will greatly aid in
assembling the shade/diffuser assembly.
3. Fit shade (B) over diffuser in one spot. Hold
shade in place while a second person
grasps the shade, slides their hands around
the diffuser, fitting shade in place. (Figure 2).
4. Install bottom diffuser (C) in similar manner.
Fit diffuser (C) inside the shade (B) in one
spot. Hold diffuser (C) in place while a
second person reaches inside the
diffuser (C) and slides their hands
around the inside of the shade (B),
allowing the rest of the diffuser (C) to set
down in the shade (B).
5. Remove finial (F) from fixture. (Figure
3).
6. Flip over shade/diffuser assembly
(A,B,C). Slide assembly over threaded
nipple (D) until bottom diffuser (C) rest
on fixture (F). (Figure 3).
7. Secure shade/diffuser assembly (A,B,C)
in place by attaching finial(F). Be sure
not to over tighten.
(continued)
Figure 2

Glass Installation Instructions C73
Disq Table Lamp 272865D Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 32775
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Figure 3