Hulkman Alpha 100 User manual

USER GUIDE
Model: Alpha 100
STEPS TO JUMP START YOUR VEHICLE
Insert the jumper cable into the jump
starter and connect the clamps to the car
battery.
‘’READY’’ sign shows on the screen. Start your car engine.
ABOUT THE FORCE START FUNCTION
Step 1
Why the screen shows nothing when you try to start your car ?
3 steps to fix your problem:
Step 2 Step 3
If the screen doesn’t display anything when you have correctly connected the clamps to your car, it means that your battery voltage is
extremely low, you can use the Force Start Function to enter boost mode.
1. Check the clamps connection and the product’s battery is above 20%.
2. Press the Power Button and Flashlight Button simultaneously for 2-3 seconds.
3. The screen shows “READY”, and go back to start engine ignition.
WARNING: WHEN USING THE FORCE START FUNCTION, AUTO-DETECTION AND SAFETY FEATURES WILL BE DISABLED.
ABOUT THE ERROR CODES
Error Code SolutionReason
Reverse the clamps and ensure the correct connection.
‘’+’’and ‘’-’’ poles of battery clamps reversed.
The voltage of the car battery is between 2-8V.
The product’s operating temperature is too high. (≥113°F)
Jump start the battery more than 5 times within 10
minutes, the product will automatically enter the safe
mode.
Press the Power Button and Flashlight Button
simultaneously for 2-3s to start force output.
(Force Start Function)
Please store it back to where the temperature is
between -40°F to 113°F.
The safe mode will be off automatically after 10
minutes waiting. (Please do not turn off the product
during the process)
Charge the device at extremely low or high temperature. Please charge the device at room temperature.
4000A 10L 10L
PEAK AMPS GAS DIESEL
32,000mAh
ULTRA-LARGE BATTERY CAPACITY

ABOUT DUAL USB-A OUTPUT PORTS:
ABOUT 12V DC OUTPUT PORT (MAX 15V/10A)
USB-A USB-A
1.Plug the cable into the USB-A output port. 2.Press the Power Button.
ABOUT PRE-HEAT TECH
1.Insert the jumper cable into
the jump starter and connect
the clamps to the car battery.
2.The Pre-Heat Function will operate
automatically and the icon will be
displayed on the screen when
the detected temperature is below
the ideal operating temperature.
3.The screen will show "READY"
after preheating , then start your
car engine.
1.Plug the 12V cigarette lighter
socket adapter into the 12V DC
output port.
2.Connect your 12V DC appliances to
the ciga-rette lighter adapter.
3.Press the Power Button.
12V DC
ABOUT LED FLASHLIGHT
1.Hold the Flashlight Button for 1-2s.
2.Press briefly to switch the light modes.•50% Lumen Light →100% Lumen Light →White
Strobe Light →White SOS Light →Red Strobe Light
Flashlight
Button
CONTACT US
https://support.hulkman.com 46 Smith Alley, Suite 200 Pasadena, CA 91103 [phone] [email protected]