Hussh Twin User manual

Instruction manual Twin cradle ©Hussh Page 1
IMPORTANT: PLEASE KEEP FOR FUTURE REFERENCE. READ THE INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLING THE CRADLE!
Here it is: your very own Hussh hanging twin cradle. There’s quite a
chance you’re going to be rather pleased with this absolute dream of a
baby’s bed. Because it’s a little different from the others, made with
particularly personal care and so very, very comfy.
The cradle is ‘handmade’ by Dutch hands. This makes each cradle truly
unique. Small imperfections and deviations demonstrate the individuality
of each product. However, should the cradle not live up to your
expectations, do not hesitate to let us know!
Before assembling the hanging cradle, please check if you have all
the parts listed below.
Parts twin cradle: 1 cotton cradle with partition and support plate.
2 sligthly hollow mattresses with integrated bottom
board.
5 long rods.
4 legs.
1 spring with safety line.
4 suspension ropes.
1 hardware set: 8 carbine harnesses (6 and 7 cm
long), 4 eye nuts, 4 ‘adjusting eights’
Swinging hook set (optional order): 1 swinging hook + plug
Heavenly canopy items (accessory):1 canopy with 1 carbine harness (6
cm)
Warning!
Read the product conditions prior to use on www.hussh-cradles.com
Use of the spring: the spring must be used under normal conditions. The
manufacturer understands ‘normal’ not to include turning/twisting or a
sudden offload (discharge) of the spring. Consequently, children should
never be allowed to play with the cradle and/or the spring.
Always use the spring with the attached safety line.
How to suspend the hanging cradle from the ceiling
The hanging cradle is suspended from a swinging hook in the ceiling. This
hook can be screwed directly into a wooden beam (after predrilling). If
you have a concrete ceiling, use the plug. Test the safety of your
construction and make sure the hook can hold quite its share of weight!
Note: when screwing in the hook do not use much force as this can
weaken the hook.

Instruction manual Twin cradle ©Hussh Page 2
IMPORTANT: PLEASE KEEP FOR FUTURE REFERENCE. READ THE INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLING THE CRADLE!
How to assemble the hanging cradle
For good-looking results, please take your time assembling the cradle.
This is especially important when determining the required rope length, as
well as when adjusting the level of the cradle so that it is truly horizontal.
If your infants gain weight, or start to sleep at the foot (or head) of the
bed, adjust the ropes accordingly so the cradle hangs horizontally once
more.
We recommend you iron the cradle (cotton) and heavenly canopy (linen)
before assembling the hanging cradle, preferably with a steam iron.
If you feel the cradle is too close to the ceiling (or if your ceiling is tall),
attach an extra piece of rope between the swinging hook and the spring,
thereby enabling you to lower the cradle to the desired height. It is
possible to order a separate piece of rope with an extra carbine harness
for this purpose.
When you put your infants to bed, we recommend you tuck the blanket or
duvet neatly under the mattress, so it stays flat (and level).
Enough text: time to assemble a lovely place for sleeping. Good luck! We
wish your babies many wonderful sleeping hours.
P.S. Your experience and photographs of
the Hussh hanging cradle are more than welcome!
Send them to [email protected]
They may very well end up on our website