Hussh Tripod User manual

Hussh Tripod assembly manual
It is easiest to assemble the tripod with two people. Make sure you have enough room.
Please see attached photogallery.
Ensure all nuts are tightend with the flat sides against the discs (see ‘1’ on the
photopage)
Ensure the bigger disc isn’t mounted upside down. Look at the direction of the 3 holes
(see ‘2’ and ‘3’ on the photopage)
Maintain about 10 cm (3.9 inch) distance between the two discs (see ‘5’) Fasten the
nuts somewhat. The discs should still be able to turn.
Place the discs on their side on the floor. Insert the unsinked end of (half) a ‘leg’ through
an opening in the bigger disc (see ‘7’). Now roll a rubber ring down the leg (see ‘8’).
Then, then insert the leg in the smaller disc. Leave it lying on the floor. Repeat the
process for the 2nd and 3rd leg.
‘Lock’ the legs by rolling the rubber rings completely aigainst the bigger disc.
Couple the two halves of the tripod legs using the aluminium couplings. Use bits of the
tape for a good fit of the legs in the couplings (see ‘11’ and ‘12’
Carefully place the tripod on its ‘feet’.
Again check the position of the rubber rings.
Pull the feet apart a little. This will induce some tension on the legs which improves
stability.
Now tighten the nuts firmly with the appropiate tools.
The distance between the legs can be shortened by moving the upper disc up a few
millimetres. Screw the upper nut a few millimetres up, and then also screw the nut
beneath the upper disc upward as well.
Tighten firmly!
The distance between the legs can be widened by moving the upper disc down a few
millimetres. Screw the nut beneath the upper disc down a few millimetres, and then also
screw the in upper nut down as well.
Tighten firmly!
Happy swinging!
Hussh Cradles