Huzzard HSRF-CONN-EXT-KIT User manual

Huzzard.com
[phone]
[e-mail]
.com
[phone]
January 6, 2021
pg. 1
HSRF-CONN-EXT-KIT
Installation Guide
Power Input
8 pin Plug
I. Pre-Installation Test
What is Included with
HSRF-CONN-EXT-KIT?
A. Barcode Reader Adapter
B. Coupler x2
C. Power/Serial Connection
What is Needed from HSRF-ENC-KIT
D. Barcode Reader
E. Power Supply
1. Insert non-booted end of the Barcode Reader Adapter
Booted End (Part A Above) into the Barcode Reader
(part D).
2. Insert the Barcode Reader Adapter (part A) into one of the
couplers (part B).
3. Insert the Power/Serial Connector (part C) 8 pin plug into
one of the couplers for testing (part B).
4. Insert the Power/Serial Connector 9 pin Serial into your
Windows computer.
5. Plug the Power Supply (part E) into an AC socket and the
power barrel end into the Power/Serial Connector (part C).
6. On the PC, open *Realterm and preform barcode scans
by placing curser in input window and scan any barcode
to verify proper operation and connection between
Access Control Reader and Windows PC.
7. Once the Huzzard equipment is verified as functional,
install any other user supplied equipment and run scan
tests.
8. After all equipment has been verified functional, remove
the Coupler (part B).
9. Move on to Field Installation.
*
Non-booted
Booted
9 pin Serial
*Realterm can be found at
realterm.sourceforge.io

Huzzard.com
[phone]
[e-mail]
.com
[phone]
January 6, 2021
pg. 2
HSRF-CONN-EXT-KIT
Installation Guide
1. Determine Start and End points.
a. Start Point: where the Huzzard Access Control
Reader will be located.
b. End Point: 60 feet or less from the Start Point.
2. Install the structured cabling from the start point to
the end point.
a. Cat5e or greater structured cabling.
b. Straight through cable
i. Cable will need to be terminated with male
RJ45 ends to plug into couplers.
c. Tested and certified to 60 feet or less.
3. Install Huzzard Access Control Adapter according
to the instructions supplied with the HSRF-ENC-
KIT.
4. The Barcode Reader should still be attached to the
non-booted end of the Barcode Reader Adapter
(part A) from the pre-install test.
5. Install the Barcode Reader Adapter (part A) booted
end into the user supplied cabling using supplied
Couplers (part B).
6. Install the Power/Serial Connector (part C) 8 pin
plug into the user supplied structured cabling.
7. Plug the Power Supply (part E) into an AC socket
and the power barrel end into the Power/Serial
power Connector (part C).
8. On the PC, open Realterm and preform barcode
scans by placing curser in input window and scan
any barcode to verify proper operation and
connection between Access Control Reader and
Windows PC.
II. Field Installation
*The Barcode Reader Adapter (Part A) is not an ethernet cable. Do not plug the adapter cable kit cables into an
Ethernet device. Also, the power supply that ships with the HSRF-EXT-KIT is the only power supply that is approved for
use. Third party adapters or power supplies will damage the Access Control scanner.
For further support, Email [email protected], Call [phone] ext. 131, or visit our webpage
https://huzzard.com/door-access-control/
*
Please Note
*