HydroTherm DYNAMIC-SS/X8/OP User manual

Welcome to the future of hot water.
A5 ERROR  SOLUTION GUIDE
DYNAMIC - SS/X8/OP
DYNAMIC - SS/X8/C

2
1. Hold down‘MODE’until the word‘PASS’appears on
the display. This requires you to enter the password.
The password for each machine is 4-3-2-1.
2. Press ‘UP ARROW’ to change ‘PASS’ to ‘0000’. To
enter the password, adjust each number using the
‘ARROW’ buttons and select ‘TIMER’ to confirm.
When the password has been correctly entered,
press ‘TIMER’. ‘F11’ will appear on the display.
3. Press the ‘UP ARROW’ until you arrive at F50,
press ‘TIMER’ and a number will appear on the
screen. Using the ‘DOWN ARROW’ change the
value to “0”. Press ‘TIMER’ to exit.
A5 SOLUTION GUIDE
An A5 error is caused by an oversensitivity in the pressure switch which is a safety
precaution for cold climates. Changing these settings will not affect the performace
of the unit.
MODE
TIMER
4 Repeat step 3 for F54 and F57.
TIMER
TIMER

3
5. To exit settings press ‘UP ARROW’ until ‘END’
appears on the screen, then press ‘TIMER’. The
clock will reappear on the screen. Ensure system
is on.
TIMER

[e-mail]
www.hydrothermhotwatersystems.com.au
TOLL-FREE 1300 769 904