Do not lean. Keep a good seating and balance at all times.
To maintain tools and accessories carefully, keep cutting tools sharp and clean for better and
safer performance. Follow the instructions in this manual to lubricate and change accessories.
Always inspect the machine before and after operation. If the tool is damaged or faulty, stop
using the tool and bring it to an authorized service for inspection and repair.
Turn off the tool after use, when you leave it unattended, when changing these accessories
and before servicing.
Keep handles dry, clean and free from oil and grease.
Be concentrated when using the tool. Look at what you do, make sense and do not use the tool
when you are tired.
Remove the blade guard before using the tool.
A damaged guard or other part must be properly repaired or replaced by an authorized service
center, unless otherwise specified in this instruction manual.
Do not use the tool if the starter is not working (if it cannot be turned ON and OFF).
Place the equipment in a well-lit area on a flat, stable, dry and well-ventilated surface, away
from flammable materials and with plenty of space for sparking and sharpening waste.
Do not allow anyone, especially children, to come within a radius of at least five meters around
the work area when all work is in progress.
Immediately stop the tool in the event of a malfunction of the motor or the ON/OFF button or in
case of unusual noise.
Do not use the tool if the starter is damaged.
Do not move the chain with your hand with the wheel moving.
Do not stop the chain with your hands or other objects.
Treat the chain teeth with caution during operation; they can cause severe cuts.
When not in use, the machine must be stored in a dry, locked place out of the reach of children.
Before using the product and after any shock, please check it for signs of wear or damage.
Please carry out repairs if necessary.
Always switch off the machine:
oEvery time you leave the device unattended;
oBefore releasing an obstruction;
obefore checking, cleaning or working on the product;
oafter hitting a foreign object;
oEvery time the product starts to vibrate abnormally.
Pay attention to foot and cutting injuries.
Inspect and regularly service the product. Repairs should be carried out only by an authorized
service center or a similar qualified specialist.
When not in use, store the product out of the reach of children.
Children should not play with plastic bags, sheets and small parts! Keep them out of the reach
of children. There is a danger of suffocation!
When transporting the tool, always add the blade guard to the blade. Always carry the tool by
holding the handle, never the blade.
Do not use the product on a slippery surface.
Do not use the product on steep, slippery slopes.
When planning your work schedule, allow enough time for rest. Limit continuous use of the
device, e.g. use 30 ~ 40 minutes per session, and take 10 ~ 20 minutes of rest between work
sessions. Work a maximum of two hours per day
If the machine has struck foreign objects, check if the tool is damaged and bring it to repair if
04
