ibis OSO Guide

OSO
BATTERY MOUNT
ADJUSTMENT GUIDE

1
OSO | BATTERY MOUNT INSTALLATION GUIDE
TOOLS REQUIRED
• T20, T30 Torx key
• 2.5mm, 3mm, 4mm and 6mm Allen keys
• Torque Wrench with T20, T30, 4mm and 6mm Allen bits
• Rag

2
OSO | BATTERY MOUNT INSTALLATION GUIDE
PROCEDURE
STEP 1
• Remove the battery door and the battery.
STEP 2
• Use a T20 key to ensure the bolts holding the lower battery cradle to the lower battery mount
are tight. Torque: 2Nm
STEP 3
• Install the battery.
• Tighten the front battery mount snug then back it out 3/4 turn.
Torque: 2Nm

3
OSO | BATTERY MOUNT INSTALLATION GUIDE
STEP 4
• Remove the downtube guard and motor cover.
• Loosen the two bolts which hold the lower battery cradle. Depending on which bolts you have
it may require either a 4mm, 5mm, or T30 Torx key.
• Remove one bolt at a time (to prevent the “nut” that the bolts thread into from falling into the
frame) and reapply Loctite 243 to the threads. Reinsert the bolts and partially thread them
back into the lower mount.
Loosen with 4mm
or 5mm Allen key,
or T30 Torx key

4
OSO | BATTERY MOUNT INSTALLATION GUIDE
STEP 5
• Use a long 6 or 8mm Allen key to apply moderate pressure on the center of the back of the
battery cradle.
• Installation torque depends on which bolts your bike is equipped with. Tighten bolts with a 4mm
Allen bolt head to 12Nm and bolts with a T30 Torx or 5mm Allen bolt head to 15Nm.
NOTE: If your bike has 4mm Allen head bolts and you need to adjust the mount frequently, you may
need bolts that can handle a higher installation torque. Please reach out to askchuc[email protected]
for more information.
STEP 6
• Remove the battery.
• Reinstall it to make sure it lines up correctly.
• Tighten the front battery mount to 12Nm with a 6mm Allen key.

5
OSO | BATTERY MOUNT INSTALLATION GUIDE
STEP 7
• Visually inspect the interface between the battery cradle and the battery to ensure the foam
contacts the battery.
No Gap
STEP 8
• Turn on the bike to ensure it functions.
• Replace the downtube guard, battery door, and motor cover.
QUESTIONS?
askchuc[email protected]

IBIS CYCLES | 1201 SHAFFER ROAD, BUILDING 1B | SANTA CRUZ, CA 95060 | IBISCYCLES.COM