ICO CALMA Tempo User manual

INSTALLATION GUIDE
877 757 8930
[email protected] | www.icobath.com
Before installation, check the product for any
shipping damages. If you nd damages, do not
install and contact your dealer or ICO.
Getting Started
Any wall to which the vanity will be installed must
be of suitable construction to support the product’s
weight.
Required Tools and Materials
Vanity Installation
1
Tempo Vanities
Unpack your vanity and set it on the oor –
ensure you lay out oor protection – cardboard,
towel etc.
Add legs to each side, and secure them from the
inside of the vanity using the provided screws.
3

877 757 8930
[email protected] | www.icobath.com
Add provided shelf screws to the legs.
4
Add levellers to the bottom of the legs.
5
INSTALLATION GUIDE
Tempo Vanities

Predrill and install drywall anchors – we
suggest an 8mm - 1/8 inch bit (not necessary if
mounting into studs) – screw the vanity to the
wall.
877 757 8930
[email protected] | www.icobath.com
7
FOR VANITY WITH SHELF - add shelf to the
vanity and tighten using the fasteners on the
bottom of the shelf.
6
Remove the decorative cap on each side of the
drawers. This is located near the front of the
drawer on the inside.
8
INSTALLATION GUIDE
Tempo Vanities

877 757 8930
[email protected] | www.icobath.com
Use the top screw to adjust the vanity drawer
from side to side.
Silicone the top edges of the vanity, and place
sink/top – allow 24 hours for silicone to dry
and cure.
9
10
Use the bottom screw to adjust the vanity
drawer up and down.
INSTALLATION GUIDE
Tempo Vanities
Thank you for choosing Calma!
Exhibit your Style
Snap a picture, share and tag us:
@ico_bath