Iconasys Silver Series User manual

1
© Imagen Labs, LLC DBA Iconasys 2013-2020
Silver Series Turntable Mobile Phone Mounting Kit
Set-up Guide
Along with the purchase of the Mobile Phone Mounting Kit, you would have
received:
A. Turntable Mount (+3 screws to mount to the Turntable motor stem collar)
B. Stem Riser (+1 screw to mount to ‘Turntable Mount’):
C. Connectors:
oLightning Mount (compatible with Apple phones & tablets)
oUSB Type C Mount (compatible with newer Android phones & tablets)
oUSB Micro Mount (compatible with older Android phones & tablets)
A
B
C

2
© Imagen Labs, LLC DBA Iconasys 2013-2020
Getting Started with the Mobile Phone Mounting Kit
Users will first want to remove the master platform of the turntable, this can be
done by removing the 3 center screws then lifting the top off.
After the turntable master platform has been removed, you will connect the ‘Stem
Riser’to the ‘Turntable Mount’using the single screw (insert this into the underside
of the Turntable Mount and connect to Stem.

3
© Imagen Labs, LLC DBA Iconasys 2013-2020
Next, use the 3 screws that were used to mount the turntable platform to connect the Hanging
Kit Mount to the center stem:
Last, connect a ‘Connector’to the ‘Stem Riser’by screwing this into the top of the Riser.
Questions? Please reach out to our technical support department:
https://www.iconasys.com/technical-support/