ICRealtime PWR-HIPOE-8 User manual

8-Port PoE Switch User’s Manual
V1.0.0

Important Safeguards and Warnings
Please read the following safeguards and warnings carefully before using the product in order to avoid
damages and losses.
Note:
Do not expose the device to lampblack, steam or dust. Otherwise it may cause fire or electric shock.
Do not install the device at position exposed to sunlight or in high temperature. Temperature rise in
device may cause fire.
Do not expose the device to humid environment. Otherwise it may cause fire.
The device must be installed on solid and flat surface in order to guarantee safety under load and
earthquake. Otherwise, it may cause device to fall off or turnover.
Do not place the device on carpet or quilt.
Do not block air vent of the device or ventilation around the device. Otherwise, temperature in
device will rise and may cause fire.
Do not place any object on the device.
Do not disassemble the device without professional instruction.
Warning:
Please use battery properly to avoid fire, explosion and other dangers.
Please replace used battery with battery of the same type.
Do not use power line other than the one specified. Please use it properly. Otherwise, it may cause
fire or electric shock.
Special Announcement:
This manual is for reference only.
All the designs and software here are subject to change without prior written notice.

If there is any uncertainty or controversy, please refer to the final explanation of us.


Table of Contents
1Product Overview............................................................................................. - 1 -
1.1 Features............................................................................................................................- 1 -
1.2 Typical Application............................................................................................................- 1 -
2Device Structure............................................................................................... - 3 -
2.1 Port...................................................................................................................................- 3 -
2.2 PoE...................................................................................................................................- 3 -
2.3 Install Ear..........................................................................................................................- 4 -
Appendix 1 Technical Specification ............................................................... - 5 -
Appendix 2 Toxic or Hazardous Materials or Elements................................ - 6 -

- 1 -
1 Product Overview
8-port PoE switch is a lay 2 switch which supports Power over Ethernet. It is widely applied in school,
community, office and other environment where fewer wiring is preferred
1.1 Features
1*1000Mbps SFP optical port, 1*10/100/1000Mbps electrical port, and 8*10/100Mbps PoE
electrical ports.
Switch capacity 5.6Gbps, including transmission rate 8.3 Mbps.
IEEE802.3af, IEEE802.3at, and PoE total power of 120W.
Up to 8K MAC address entries with automatic learning and aging.
Port self-adaptive MDI/MDIX modes.
Metal plate, brand new design.
AC 110V, AC 220V power supply.
1.2 Typical Application
The typical application of fiber transceiver is shown in Figure 1- 1

- 2 -
Figure 1- 1

- 3 -
2 Device Structure
2.1 Port
The front panel is shown in Figure 2- 1.
Figure 2- 1 PWR-HIPOE-8
No.
Name
Function
1
No. 1~8
8*10/100Mbps electrical ports.
2
10/100/1000Base-T
1*10/100/1000Mbps electrical port.
3
1000Base-X
1*1000Mbps SFP port.
4
PWR, Link/Act
PWR: power indicator.
Link/Act: optical link indicator.
The rear panel is shown in Figure 2- 2.
Figure 2- 2 PWR-HIPOE-8
2.2 PoE
8-port PoE switch has a total of 8 100Mbps electrical ports all supporting PoE. Please be careful
with the following:
Electrical port 1, electrical port 2 support 60W, IEEE802.3af, IEEE802.3at.
Electrical port 3 electrical port 4 support IEEE802.3af, IEEE802.3at.
Electrical port 5, electrical port 6, electrical port 7, electrical port 8 support IEEE802.3af.

- 4 -
2.3 Install Ear
8-port PoE switch supports installation in rack or on surface. For installation in rack, please refer to
the following instruction.
Figure 2- 3 Ear Installation

- 5 -
Appendix 1 Technical Specification
Product Model
PWR-HIPOE-8
Physical Port
Network Port
1 10*100Mbps SFP optical port, 1 10*100Mbps electrical port, 8 100Mbps
electrical ports.
Technical Specification
Switch Capacity
5.6Gbps
Transmission Rate
8.3Mpps
Switch Mode
Storage and transmission
MAC Learning
MAC auto learning and aging, MAC address list capacity is 8K.
POE Standard
IEEE802.3af, IEEE802.3at
General
Power
AC 220V
Consumption
≤150W
Temperature
-10℃～＋55℃
Humidity
10%～90%
Weight
＜3kg
Dimension
300mm×220mm×44.4mm
Installation
In rack, on surface

- 6 -
Appendix 2 Toxic or Hazardous Materials
or Elements
Component
Name
Toxic or Hazardous Materials or Elements
Pb
Hg
Cd
Cr VI
PBB
PBDE
Circuit Board
Component
○
○
○
○
○
○
Device Case
○
○
○
○
○
○
Wire and Cable
○
○
○
○
○
○
Packing
Components
○
○
○
○
○
○
Accessories
○
○
○
○
○
○
O: Indicates that the concentration of the hazardous substance in all homogeneous materials in the parts
is below the relevant threshold of the SJ/T11363-2006 standard.
X: Indicates that the concentration of the hazardous substance of at least one of all homogeneous
materials in the parts is above the relevant threshold of the SJ/T11363-2006 standard. During the
environmental-friendly use period (EFUP) period, the toxic or hazardous substance or elements
contained in products will not leak or mutate so that the use of these (substances or elements) will not
result in any severe environmental pollution, any bodily injury or damage to any assets. The consumer
is not authorized to process such kind of substances or elements, please return to the corresponding
local authorities to process according to your local government statutes
Note
This user’s manual is for reference only.
Slight difference may be found in user interface.
All the designs and software here are subject to change without prior written notice.
All trademarks and registered trademarks are the properties of their respective owners.
If there is any uncertainty or controversy, please refer to the final explanation of us.
Please visit our website for more information.