INSTALLATION INSTRUCTIONS
Locate the wall stud and mark the top hole of the
Wall Track, drill 11/64 pilot hole and insert #14 screw
and tighten slightly. Use a level, mark the lower holes,
drill pilot holes and then insert the #14 screws, again
making sure the unit is level. NOTE 1: ICW supplies # 14
Wood screws. If installing into metal studs, you will
need to replace these with proper metal stud fasteners.
Remove small socket head cap screw
in the top middle of the Wall Track.
Insert the Slider into the Wall Track as shown right and
replace the small socket head cap screw. If you have
chosen to mount your LCD underneath the arm assembly
simply turn the Slider upside down and insert into the Wall
Track. You cannot mount the LCD under the arm assembly
if the Keyboard option is used.
UL90 to VESA MONITOR
Using the 5/32” hex key
wrench, attach the VESA
plate to the friction mount.
To mount the monitor
lower you can also mount
the VESA upside down
with the screw holes at
the top. Using a phillips
screw driver, attach the
VESA plate to the back of
your LCD monitor.
Once you have adjusted the slider to the desired height,
tighten down the track slider using the handle on the
slider as shown.
Installation instructions for the Ultra 390 track slider series.
II013 Revision B. 2-21-03 MF
Products names, photo’s, and drawings contained in this document are Copyright ©2003 ICWUSA.com, Inc.
