If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc. If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc.
VT21 INSTALLATION
Page 4 of 5
Track and track adapters sold
separately
MOUNT TRACK
FOR WOOD STUD
Center mounting option
Locate the wall stud and mark the top center hole of the wall track. Drill a
11/64 pilot hole, insert a #14 screw and tighten slightly. Using a level, mark
the lower holes in the center of the track, drill pilot holes and then insert the
#14 screws. Use all screws.
Right or left mounting option
• Locate the wall stud. Align either right or left side of track with stud and
mark one hole in the upper corner for track placement. Drill 11/64” pilot
hole. Insert #14 screw and tighten slightly.
• Using a level, mark the remaining holes on the same side, drill pilot holes
into stud. Insert #14 screws and, with the unit level, tighten screws.
• Insert provided Snap Togglers into outer corner holes on opposite side.
See below.
FOR METAL STUD
#14 wood screws are supplied with unit. If installing into metal studs you
will need to replace these with proper metal stud fasteners or provided
snap toggles. All hardware used to secure track mount must have a proper
countersunk head.
Attach beauty cap.
When mounting to studs, ICW
recommends using only wood
or metal studs. This is the basic
method to mount the arm on a stud.
Check building code regulations
in your area for additional
requirements.
The plastic straps and cap washer are positioning and
retention elements only. They do not otherwise function as
anchoring elements. Holding is dependent only on a metal
bolt to metal channel connection. The SnapToggle anchor
complies with all existing re codes for critical applications.
Handle Cap Straps Anchoring
Channel
Drill 1/2” hole. Hold metal
channel at alongside
plastic straps and slide
channel through the hole.
Minimum clearance behind
wall is 1-7/8”
Hold ends of straps together
between thumb and fore-
nger and pull toward you
until channel rests behind
wall. Ratchet cap along straps
with other hand until ange of
cap is ush with wall.
Place thumb between straps
at wall. Push thumb side
to side, snapping off straps
level with ange of cap.
Place track over ange.
Insert provided bolt and
tighten until snug against
track, then stop.
Snap Toggle Instructions
VT21 INSTALLATION - rev 10/6/15 pjm
IF ATTACHING VTTM TO WALL TRACK
