AutoStand_Plus_Manual_US-EN_2021-04 1-866-828-6737 idealwarehouse.com 2021-04-27
Step 4:
Once the AutoStand Plus has reached the underside of the
trailer, pull back on the hand lever, locking the unit into place.
Note: You may need to step on the foot plate to find the closest
hole for locking pin.
Step 5:
Ensure the AutoStand Plus is as close to the underside of the
trailer as possible. In some cases there will be a small gap
between the top of the stand and the underside of the trailer.
Step 6: Ensure the AutoStand Plus is in the correct locked
position to avoid potential injury to personnel or damage to
equipment. The locking pin should be fully inserted through the
center mast of the stand. If the pin is not fully inserted, repeat
steps 3-5.
Critical safety tip:
If the AutoStand Plus Trailer Stand does not have enough range to reach the underside of the
trailer, use other means to protect against landing gear collapse and trailer tip over.
Removing the AutoStand Plus Trailer Stand
Complete all of the previous steps in reverse order.
Critical safety tip:
If you are unable to remove the locking pin, there may be an unsafe condition the AutoStand
Plus has prevented. Removing it at this point may cause a larger accident. Contact the loading
dock supervisor for assistance as the trailer may need to be supported by other means before
the AutoStand Plus can be safely removed.
Once removed, store the unit out of the way of dock traffic, indoors, and complete a visual inspection to
ensure there are no obvious maintenance issues.
Warranty Statement
Ideal Warehouse Innovations, Inc. warrants for a period of three hundred and sixty-five (365) days from date of installation, or three hundred and seventy-five (375) days from date of shipment,
whichever shall occur first, that all products and service parts shall be free from defects in workmanship and material. If the equipment or any part thereof, is returned, transportation charges pre-
paid, within the periods specified above, and if examination by Ideal Warehouse Innovations, Inc. discloses to its satisfaction that the said equipment or part thereof has been defective in workmanship
or material, it will deliver to the purchaser, without charge, parts of the first class workmanship and material in exchange for any parts so found to be defective, and Ideal Warehouse Innovations, Inc.
is limited to said exchange.
This warranty shall not apply: (1) to maintenance service or adjustment; and (2) to any equipment which shall have been repaired or altered outside of Ideal Warehouse Innovations, Inc. or its
authorized service representatives.
These warranties are in lieu of all other warranties, expressed or implied, including, without limitation, warranties of merchantability and fitness for purpose, all other representations to the first user
purchaser, and all other obligations or liabilities, including liability or incidental and consequential damages, on the part of Ideal Warehouse Innovations, Inc. No person is authorized to give any other
warranties or to assume any other liability on behalf of Ideal Warehouse Innovations, Inc. unless made or assumed in writing by Ideal Warehouse Innovations, Inc.
