Idis DA-JB2300 User manual

DA-JB2300 INSTALLATION MANUAL
This manual is intended for users of the DA-JB2300 junction box. It
includes instructions for mounting the DA-JB2300 junction box to a wall.
• This junction box is intended to be used with DC-T series model
of camera. Do not use it with other models of cameras.
• This installation should be performed by a qualied service
personnel in conformance to all local codes.
• You may need to reinforce the wall. If the wall is not strong
enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
Mounting
Mount the junction box to the wall or mounting bracket as follows:
Wall
Cable
Junction Box
3/4" Cap
Wall Hole
Bracket
Junction Box Cable
Bracket
Junction Box Cable
1 Insert cables from external devices, network and power adapter to the junction box.
2 Mount the junction box to the wall or mounting bracket by using the screws.
• Use the provided guide pattern to check the distance between the screw holes if necessary.
• If you want to insert cables through the bottom of the junction box, remove the 3/4" cap and
attach it to the wall hole.
Rubber
Cable Junction Box
Mounting
Bracket
Cable
Junction BoxRubber
Cable Clamp
Cable
Junction Box
Rubber
4 Route the cable from the camera through the rubber and then junction box. Attach the rubber
onto the junction box.
5 Fix the cables using the cable clamp.
6 Connect the cables from external devices, network and power adapter to each port of the
camera.

IDIS Co., Ltd.
For more information, please visit www.idisglobal.com
7 Close the junction box by using the screws.
Make sure that the rubber is attached onto the junction box.
Connect your camera to the junction box as follows:
8 Screw the mounting bracket onto
the junction box, then the camera
body onto the mounting bracket
by using screws.
Junction Box
Mounting Bracket
Dimensions
Unit: mm (inch)
155 (6.1)
138.5 (5.45)
4-M5TAP
54 (2.12)
4-M5TAP
Ver.1.0