iGadgitz AJ65C User manual

Page 1of 6
iGadgitz Stereo Bluetooth Travel Speaker (AJ65C)
User Guide
For more instructions in English
please visit:
www.igadgitz.com/guides
Eine Anleitung in Deutsch nden Sie
unter:
Para obtener instrucciones en
Español por favor visite:
Pour obtenir des instructions en
Français s'il vous plaît aller à:
Per istruzioni in Italiano si prega di
visitare il sito:
Safety and General Information
Please read the following information before using this product.
1. Do not use the product while operating a motor vehicle.
2. To avoid electronic interference and/or compatible conflicts, turn off the
product in any facilities where posted notices instruct you to do so. For
example: Aircraft, Military Base, Hospital or Health Care Facilities.
3. To avoid impairing your hearing, keep the speaker volume at a moderate
level. Do not listen at high volumes for prolonged periods. Check volume
before turning on.
4. For your safety, avoid distractions from music or phone calls while in
public places or potentially dangerous environments.
5. Keep away from fire, water, and high voltage equipment.
6. Dot not install, place or use the speaker near any source of heat such as
a cooker, radiator, oven, toaster, coffee maker or other apparatus
(including microwave ovens) that gives off heat. Do not use in direct
sunlight.
7. It is recommended to keep the environment temperature between 15°C
& 25°C
8. Follow the battery and charging procedure in this guide to charge the
product.
9. Do not use chemicals or detergents to clean the product.
10. The speaker should not be submerged or exposed to water. Do not
charge if damp or wet. Ensure fully dry before charging.
11. Should the unit become hot to touch or emit smoke, switch off at the
mains, disconnect and contact the manufacturer.
IMPORTANT WARNING: Do not connect to a PC or USB charger
if speaker is damp or wet. Danger of electrocution.

Page 2of 6
Product Overview
With Bluetooth wireless technology, this iGadgitz AJ-65C Bluetooth speaker
gives you the convenient wireless way to enjoy the streaming stereo music
transmitted from the Bluetooth A2DP*1-Source device such as MP3 players,
Smartphones, PC/Laptop or Tablet in the available range.
You can use AJ-65C to remotely control the music playing functions of your
Bluetooth device if it supports Bluetooth AVRCP*2.
Switching between music and phone calls, AJ-65C also allows you to answer or
make calls with a Bluetooth-enabled phone*3while you are listening to music.
After you end the call, the music will continue to be streamed in seconds*4.
Besides the wireless stereo and mobile hands-free applications, you can apply
the AJ-65C to a Bluetooth-enabled PC*5with the instant messaging applications
such as Skype.
Notes:
*1: The playback or its plug-in Bluetooth adapter/transmitter needs to support Bluetooth
A2DP (Advanced Audio Distribution Profile).
*2:The playback or its plug-in Bluetooth adapter/transmitter needs to support Bluetooth
AVRCP (Audio Video Remote Control Profile).
*3: The mobile phone needs to support Bluetooth HFP (Hands-free Profile) and support
Bluetooth A2DP (Advanced Audio Distribution Profile).
*4: Some mobile phones do not release the connection switch function to the speaker, which
will cause the speaker to fail to switch the Bluetooth connection between music and call.
*5: The computer or its plug-in Bluetooth adapter needs to support Bluetooth HSP (Headset
Profile).
Specification and technical parameters
Rated impedance: 4 Ohm
Rated Power: 3W
Frequency response: 2dB
Frequency Scope: 180Hz
Sensitivity: 80dB+/-2dB
RMS: 1.3W
SNR: >/=80dB
Battery: Built-in Lithium-ion Rechargeable
Performance: Bluetooth Specification V2.1+EDR class 2, up to 10 meters (in open
space)
Operating distance: 10m (33 ft)
Music/Talk time: 8 hours*
Charging time: 2 hours
Bluetooth profiles supported:
HSP Profile (Headset Profile)
HFP Profile (Hands-free Profile)
Charging Input: DC5.0V
Aux in: 3.5mm audio jack
Dimensions: 60 x 60 x 57mm
Weight: 191g
*The maximum operating time depends on the usage frequency and environmental factors. A long distance wireless
connection and use with a mobile phone will increase the power consumption.

Page 3of 6
Diagram
Ref
Function
1
Play/Pause/Mode
2
Prev track
3
Next track
4
LED light
5
Volume dial
6
Line-in port
7
USB-in port
8
Microphone
9
Micro SD/TF Card slot
10
On/Off switch

Page 4of 6
How to use AJ-65C
Turn on the speaker
When the speaker is off slide the switch on the bottom of the speaker to the On
position. The blue LED light will turn on.
Turn off the speaker
When the speaker is on, slide the switch on the bottom of the speaker to the Off
position.
Paring
Pairing is the process of establishing encrypted link between AJ-65C and Bluetooth
devices.
Step-1 Make sure the AJ-65C is switched off, then slide the switch on the bottom of
the speaker to the On position. The LED light will flash quickly green and blue if it is
searching for new devices to pair with.
Step-2 Follow the operating instruction of your Bluetooth device to start the pairing
process. Typically, this is done by going to a “Connect” or “Setup” menu and then
selecting the option to search for AJ-65C that is still in the pairing mode.
Step-3 The mobile will find AJ-65C and ask whether you are willing to connect your
device with the speaker. Press “Yes” or “Confirm” to confirm this action.
Step-4 Your device’s display might then prompt you for a passkey or PIN. Enter
0000 (a sequence of four zeros) and the display should prompt the pairing result.
If the connection is successful, the LED will flash every 2 seconds. If the pairing is
unsuccessful, please turn off the speaker and turn it on again. Then, return to
Step-1 and do the pairing procedure again.
Make a Call
Step-1 Use the mobile phone’s keypad to dial the phone number.
Step-2 Press mobile phone’s “Send” or “OK” key. The mobile phone initiates the call
and transfer the call from the mobile phone to the speaker.
Answer a Call
Step-1 If there is an incoming call while you are listening to the streaming music,
you will hear your ring tone through the speaker.
Step-2 Just press Play/Pause/M key one time.
End a Call
Use either of the following methods to end a call.
Method-1 Press Play/Pause/M key one time to end a call from the speaker.
Method-2 End a call from the mobile phone’s keypad.
If you are listening to music when there is an incoming call the speaker will switch
the connection from the music player (A2DP) to the mobile phone (HSP or HFP); the
streaming music will be paused temporarily. After you end the call, the music will
should be played and streamed to the speaker again.
Notes: When you press Play/Pause/M key to answer or end a call, please
just press one time. Do not press and hold.

Page 5of 6
Adjust volume
In call mode or music mode, slide the volume dial to adjust volume.
Play/Pause music
In idle state, press Play/Pause/M button one time to play or pause music.
Previous/Next song
When playing music, you can press “forward” button to play previous song and
“backward” button to play next song.
FM Radio
To use the FM Radio, insert the 3.5mm audio cable and press and hold the
Play/Pause/M button for 3 seconds to switch to FM mode. Then single-press the
Play/Pause/M button to search for stations automatically.
Pressing the ‘Forward’ and ‘Backward’ buttons will go to the next and previously
found stations. The LED light turning green indicates a station has been found.
Micro SD/TF Card
Inserting a Micro SD/TF Card into the card slot will automatically switch music to this
type of media. Insert the card until your hear a click. The LED light will flash slowly
to indicate music is playing.
Press the Play/Pause/M button one time will play or pause music. You can press
“forward” button to play previous song and “backward” button to play next song.
Audio formats MP3, WAV and WMA are supported.
To remove the card, push the card in until you hear a click. The card will then be
pushed out by the mechanism enough to be pulled out with the tips of fingers.
Should you not hear the click releasing the card use the side of a coin to press on the
side of the card.
Line-in Mode
Insert a 3.5mm audio cable to the ‘Line in’ port. Then press and hold the
Play/Pause/M button for 3 seconds to switch modes. The LED indicator light will
flash green in quick then slow alternate flashes
Troubleshooting
If disconnection occurs, please check the following factors:
1) Ensure that the speaker has enough power, it is turned on and has been
successfully paired to the mobile.
2) The Bluetooth function of the mobile is enabled.
3) Check whether the range between the speaker and mobile is over 10 meters
(about 30 feet.) Or there is wall or other disturbance or other electrical devices
between speaker and mobile.

Page 6of 6
Battery and Charging Procedure
AJ-65C uses a rechargeable battery. A normal charging process takes
about 2 hours. The red LED will turn on when charging and will turn off
when charging is finished. Do not charge for longer than 3 hours. This
will shorten the lifetime of the battery.
Plug the USB cable into a PC/Laptop USB port or suitable 5.0V USB
power charger. Using any incorrect power supply device will cause
damage and void the warranty.
Should the unit become hot to touch or emit smoke, switch off at the
mains, disconnect and contact the manufacturer.
After charging has finished, please remove the cable from the speaker.
Do not charge the speaker for long periods of time.
When the battery is nearly used up, the blue LED will flash continuously.
Please charge the speaker at this time.
Please make sure the battery has been fully charged and fully
discharged for the first three uses to ensure optimum battery
performance.
Do not use the speaker in too hot or too cold environments. It is
recommended to keep the environment temperature between 15°C and
25°C.
Dot not connect, place or use the speaker near any source of heat such
as a cooker, radiator, oven, toaster, coffee maker or other apparatus
(including microwave ovens) that gives off heat. Do not use in direct
sunlight.
IMPORTANT WARNING: Do not connect to a PC or USB charger
if speaker is damp or wet. Danger of electrocution.
www.igadgitz.com
igadgitz™ is a registered trademark of INNOV8 GB Ltd. All rights reserved.
Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by the manufacturer is under license. Other trademarks and
trade names are those of their respective owners.