Buttons function instructions
LEARN MODE operation instructions
The loss of matched remote control would result in TV wall mount being unusable. The LEARN MODE is
used to learn how to use TV remote (ONLY suitable for the TV remote of popular brands.) to control TV
wall mount.
Note:
• TV remote can’t replace the all functions of matched remote control. Only LEARNING the three buttons
functions. With , and respectively.
• The user must follow the rules below when using the TV remote to control TV wall mount.
Select the alternate buttons from the TV remote, and the button that can't direct control the TV.
• If you need to erase all the button functions LEARNED, press and hold for 3 seconds and repeat
five times.
If you don't erase them, the new button functions LEARNED every time will overwrite the last button
functions LEARNED.
OK
1413
10. The Remote Control Operating Instructions
Remote control operation instructions
STEP 1: When powered, the buzzer sounds once beep, TV wall
mount will be in standby state.
STEP 2: Forward and reverse installation choices (NOTE 1:
There are forward and reverse installations for the TV wall
mount. Swinging the TV wall mount to right against the wall
that defaults to the forward installation. If it is the forward
installation, the STEP 2 is not required; If it is the reverse
installation, Press and hold for 5 seconds until the buzzer
sounds twice beep beep, Remote control is now successfully
set.
RMT-01
remote control
9. Placing the IR Receiver
Peel the backing paper. Place the IR receiver into desired position.
Make sure nothing will obstruct the transmission from where the TV will be viewed.
Do not plug into the power outlet until it is ready to be operated.
Do not open the electrical cover please.
Stop button
OK
Memory button1.Press and hold for 3 seconds, the buzzer will sound twice beep beep, The
memory is saved as location 1.
Memory button2.Press and hold for 3 seconds, the buzzer will sound twice beep beep, The
memory is saved as location 2.
Forward and reverse installation choices button (Pressing the button is invalid once in the working
condition).
+Learning button, Please read the instructions below for more info.
+To recall the button(location 1). Press and release button, and then press button,
The TV wall mount will automatically swivel to the location1 after the buzzer sounds once.
+To recall the button(location 2). Press and release button, and then press button,
The TV wall mount will automatically swivel to the location2 after the buzzer sounds once.
The left button. Press and release , the TV wall mount will swivel to the left until is pressed
or the TV wall mount swing to 90 degrees to stop.
OK
The right button. Press and release , the TV wall mount will swivel to the right until is pressed
or the TV wall mount swing to 0 degrees to stop.
OK
Follow the Key function instructions below to operate.
STEP 3: Press and release OK to return the TV wall mount flat
against the wall and hear one beep from the buzzer, the system
will then enter a working condition.
G
E
Reset mode
STEP 1: Restart the power.
STEP 2: Press and hold for 3 seconds and repeat three times. The system will start automatic
positioning: First TV wall mount with flat against the wall, then TV wall mount with
90°of lateral rotation until the TV wall mount automatically stop at 90°position.
positioning positioning
Note : the remote control should use AAA battery.
