Iiyama OWM001 User manual

User Manual
OWM001
WIFI Module SI01
M194A11
Hereby, iiyama Corporation declares that the radio equipment
type SI01 is in compliance with Directive 2014/53/EU. The
full text of the EU declaration of conformity is available at the
following internet address: https://www.iiyama.com/connect
Please refer to https://www.iiyama.com/connect to
download the User manual and driver.
Frequency Range Output Power (Max.)
2402 to 2480 MHz 6.8 dBm
2412 to 2472 MHz 18.98 dBm
5150 to 5250 MHz 15.16 dBm
RF&POWER
FCC RF Radiation Exposure and SAR Statements SAR Statement
The Wireless Screen Mirroring has been tested for body-worn
Specific Absorption Rate (SAR) compliance. The FCC has
established detailed SAR requirements and has established that
these requirements. RF Exposure Information The radio module
has been evaluated under FCC Bulletin OET 65C (01-01) and
found to be compliant to the requirements as set forth in CFR 47
Sections, 2.1093, and 15.247 (b) (4) addressing RF Exposure
from radio frequency devices. This model meets the applicable
government requirements for exposure to radio frequency waves.
The highest SAR level measured for this device was 0.085 W/kg.
This device should be installed and operated with a minimum
distance of 20cm between the radiator and your body.
RF EXPOSURE STATEMENT
Before using and operating this device, please read
thoroughly and comply with the following precautions in order
to prevent accidents or mal-operations.
Do not charge or use the device in dusty or wet conditions, to
prevent internal circuit failure.
Keep the device away from heat sources such as an electric
heater.
This device and its parts may contain some small
components, so keep the product out of reach of children to
prevent accidents.
This device is not water-resistant, please keep it dry.
The normal working temperature for the product is 0°C~40°C,
and the normal working humidity is 10%~90%.
Please contact professional service personnel for
maintenance services.
Do not insert any sharp or pointed object into the device.
Prevent the device from falls and collisions with other objects,
which may cause damages.
There are heating hole on back cover, do not spray water to it
or use damp cloth for cleaning;
Please call professional personnel for maintenance service.
STATEMENT
The image shown in this manual is indicative only. If
there is inconsistency between the image and the
actual product, the actual product shall govern.
SAFETY WARNING

CHECKING THE CONTENTS OF THE PACKAGE
WiFi Module x 1
Antenna x 2
Installation manual x 1 (this document)
WiFi SPECIFICATION
INSTALLATION PROCEDURE
NOTE Before mounting and using the Monitor, please follow the steps below to install the WiFi module. The
installation should be performed by at least two adult persons to avoid danger and injuries.
Please make sure the power cable of the Monitor is disconnected before installation.
1. Undo the screws 2. Remove the cover
3. Plug the WiFi module
into the slot
4. Lock the screws,
tighten the antenna
1. After completing the installation, turn on the monitor, and the WiFi module will run automatically.
Click "Settings" menu on the screen, you can see the following interface.
2. Click “Wi-Fi”, enter the following WiFi setting interface. Click the icon “ ”, you can turn on/o󰀨 the WiFi function.
WiFi SETTINGS
Wi-Standard：Support 802.11 a/b/g/n/ac
Bluetooth：Support BT 2.1/3.0/4.0
Operating Frequency：2.4G & 5G(5150MHz-5250MHz indoor
use)
Antenna Type:Dipole
Antenna Gain: BT/ 2.4G Wi 3dBi;5G wi 4.3dBi
Antenna Impedance:50Ω