
ENGLISH 8
INSTALLATION
The appliance must be
handled and installed by two or
more persons - risk of injury. Use
protective gloves to unpack and
install - risk of cuts.
Installation, including
water supply (if any), electrical
connections and repairs must
be carried out by a qualied
technician. Do not repair or
replace any part of the appliance
unless specically stated in the
user manual. Keep children
away from the installation site.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In the
event of problems, contact the
dealer or your nearest Aftersales
Service. Once installed, packaging
waste (plastic, styrofoam parts
etc.) must be stored out of reach of
children - risk of suffocation. The
appliance must be disconnected
from the power supply before
any installation operation - risk of
electric shock. During installation,
make sure the appliance does
not damage the power cable -
risk of re or electric shock. Only
activate the appliance when the
installation has been completed.
Be careful not to damage
the oors (e.g. parquet) when
moving the appliance. Install the
appliance on a oor or support
strong enough to take its weight
and in a place suitable for its size
and use. Make sure the appliance
is not near a heat source and
that the four feet are stable and
resting on the oor, adjusting
them as required, and check that
the appliance is perfectly level
using a spirit level. Wait at least
two hours before switching the
appliance on, to ensure that the
refrigerant circuit is fully efcient.
WARNING: When positioning
the appliance, ensure the supply
cord is not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning
or xing of the appliance must
be done in accordance with the
manufacturer instructions. It’s
forbidden to place the refrigerator
in such way that the metal hose
of gas stove, metal gas or water
pipes, or electrical wires are in
contact with the refrigerator back
wall (condenser coil).
To guarantee adequate
ventilation, the distance between
the rear of the appliance and the
wall behind the appliance should
be 50 mm, to avoid access to
hot surfaces. A reduction of this
space will increase the Energy
consumption of product. Please
remove the power cord from
condenser hook during installation
before connecting product to
power supply.