IKEA Sonos User manual

1(5)
IKEA of Sweden AB
Tulpanvägen 1
Box 702
343 81 Älmhult, Sweden
Telephone: [phone]
Org.nr: 556074-7551
IMPORTAN
SAFET
INSTRUCTION
When using an electrical device, basic precautions should always be followed, including the following:
To r
educe the risk of burns, fire, electric
shock, or injury to persons:
1
Unplug from outlet before putting on or taking off parts.
2
Close supervision is necessary when this device is used by, or near chil
dren, invalids, or
disabled persons.
3
Never operate this device if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the device to a service center for
examination and repair.
4
Kee
the cord away from heated surfaces.
5
Do not use outdoors.
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this device is used by, or near children, invalids, or
disabled persons.
3. Never operate this device if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water. Return the device to a service center for
examination and repair.
4. Keep the cord away from heated surfaces.
5. Do not use outdoors.
User manual for
30 March 2021
IKEA | Sonos – Wireless module
FCC ID: FHO-920-00632 and IC: 10912A-92000632
Module description : There are two different radios in the Wireless Module. The first radio supports
WiFi wireless Ethernet based on the IEEE 802.11 a/b/g/n standards. The 2.4 GHz communication is
limited to channels 1-11 for North America. The 5 GHz communication is controlled based on regional
regulatory requirements. The second radio supports Bluetooth Low Energy (BLE) mode (v4.2). Support
for BLE is through a dedicated chip. Operation in BLE mode is supported in the required 2.4 GHz ISM
band on channels 0-39. In addition to the radios, the Wireless Module supports wired Ethernet
communication (IEEE 802.3 100Base-TX) by using Ethernet port. In this mode of operation, the WiFi
wireless Ethernet is disabled.
Note: Wireless Module labeled with “FCC ID: FHO-920-00632” is not capable of transmitting on 2.4GHz
Channels 12 & 13. This FCC ID does not appear on the product label of non-USA product versions
(SKUs).
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical device, basic precautions should always be followed, including the following:

2(5)
Tulpanvägen 1
Box 702
343 81 Älmhult, Sweden
Telephone: [phone]
Org.nr: 556074-7551
Advice and instructions for Wireless Module
Sound level:
Lower than 55 dB(A).
Temperature interval at usage:
+10 °C up to + 40 °C/+50 up to +104 °F.
Temperature interval at storage:
18°C up to 70°C/0 up to 158°F.
Humidity:
20% up to 90% at 40°C/104°F.
Power supply unit:
The module is power by a specified DC supply
that is mains connected. The power
supply is
certified for its intended usage and evaluated for
Model:
92
00632
This appli
ance shall only be used
together with the matching DC power supply.
Installation instructions
Install module in host product
screws and
hand tighten. Install all connectors from the
host product to the wireless module.
Place the electrical
so that they do not get damaged, see
assembly instruction.
Connect the electrical cable to a
socket.
Usage of the Wireless Module
The wireless module can only be used within the scope of approval within the country from
where the
authorization was granted. IKEA strongly discourages
the use of the wireless module
outside the bounds
of the
equipment authorization. This device can only be used with IKEA
approved antenna with characteristics and gain that is compatible with the
equipment
authorization
Sound level:
Lower than 55 dB(A).
Temperature interval at usage: +10 °C up to + 40 °C/+50 up to +104 °F.
Temperature interval at storage: -18°C up to 70°C/0 up to 158°F.
Humidity: 20% up to 90% at 40°C/104°F.
Power supply unit: The module is power by a specified DC supply that is mains connected. The power
supply is certified for its intended usage and evaluated for safety.
Model: 920-00632
30 March 2021
Advice and instructions for Wireless Module:
This appliance shall only be used together with the matching DC power supply.
Installation instructions:
- Install module in host product with screws and hand tighten. Install all connectors from the
host product to the wireless module.
- Place the electrical cables so that they do not get damaged, see assembly instruction.
- Connect the electrical cable to a wall socket.
Usage of the Wireless Module:
— The wireless module can only be used within the scope of approval within the country from
where the authorization was granted. IKEA strongly discourages the use of the wireless module
outside the bounds of the equipment authorization. This device can only be used with IKEA
approved antenna with characteristics and gain that is compatible with the equipment
authorization.

3(5)
Tulpanvägen 1
Box 702
343 81 Älmhult, Sweden
Telephone: [phone]
Org.nr: 556074-7551
Changes or modifications not expressly approved by IKEA could void the user's authority to operate the
equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
To ensure compliance with FCC and ISED RF exposure requirements this device must be installed to provide a
minimum of 20cm between the device and people.
Pour garantir la conformité aux exigences d'exposition RF de la FCC et d'ISED Canada, cet appareil doit être
installé de manière à laisser un minimum de 20 cm entre l'appareil et les personnes.

5(5)
IKEA of Sweden AB
Tulpanvägen 1
Box 702
343 81 Älmhult, Sweden
Telephone: [phone]
Org.nr: 556074-7551
SAFETY REGULATIONS
Ma
ntenance and repair instructions
If any part of the
electrical system is
replaced, the electrical cable must
be disconnected
from the wall socket.
Replace the electrical part and then
connect the electrical cable to the
wal
socket.
Th
product
is now ready for use.
If the
product
still does not work,
please
contac
your nearest IKEA store
o
customer service.
PRODUCT SERVICING
Do not attempt to repair this product
yourself, as opening or removing
may expose you to
dangerous voltage
points or other risks.
SAVE THESE
INSTRUCTIONS
This device complies with Part 15 of the
FCC Rules/Industry Canada license
exempt
RSS standard(s).
Operation is subject to
the following two conditions:
(1) this device may not cause harmful
int
rference, and
(2) this device must accept any
received, including interference
may cause
undesired operation of the
device.
WARNING
Any changes or modifications to this unit
not expressly approved by the party
responsible for
compliance could void the
user’s authority to operate the
NOTE:
This equipment has been tested and found
to comply with the limits for a Class B
digital device,
pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonabl
e protection
against
harmful interference in a residential
installation.
This equipment generates, uses and
can radiate radio
frequency energy and,
if not installed and used in accordance
with the instructions, may
cause harmful
interference to radio commu
nications.
However, there is no guarantee that
interference will not occur
in a particular
installation. If this equipment does
harmful
interference to radio or television
reception, which can be determined
turning the equipment off
and on, the
user is encouraged to try
to correct the
interference by one or more of the
measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on
a circuit differ
ent from that to which the
receiver is
connected.
Consult the dealer or an experienced
radio/TV technician for help.
Manufacturer:
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC Rules/Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following easures
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAFETY REGULATIONS
30 March 2021
Maintenance and repair instructions:
-
PRODUCT SERVICING
Do not attempt to repair this product yourself, as opening or removing covers may expose you to
dangerous voltage points or other risks.
Manufacturer:
IKEA of Sweden AB
Address:
Box 702, SE-343 81 ÄLMHULT
If any part of the electrical system is replaced, the electrical cable must first be disconnected
from the wall socket. Replace the electrical part and then connect the electrical cable to the
wall socket. The product is now ready for use. f the product still does not work, please contact
your nearest IKEA store r customer service.

5(5)
IKEA of Sweden AB
Tulpanvägen 1
Box 702
343 81 Älmhult, Sweden
Telephone: [phone]
Org.nr: 556074-7551
The
out wheeled bin symbol
indicates that the item should be disposed
of separately from
household waste. The
item should be handed in for recycling
in accordance with local environmental
regulations for waste disposal. By
separating a marked item from household
waste, you will help
reduce
the volume of
waste sent to incinerators or
landfill
an
minimize any potential negative
i
pac
o
human health and the environment. For
more information, please contact your IKEA
store.
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from
household waste. The item should be handed in for recycling in accordance with local environmental
regulations for waste disposal. By separating a marked item from household waste, you will help reduce
the volume of waste sent to incinerators or landfill and minimize any potential negative impact
human health and the environment. For more information, please contact your IKEA store
30 March 2021